Search results
-
Stuck Tubing in Oil Dipstick Engine Port- PROBLEM SOLVED
PROBLEM SOLVED After a lot of twisting and pulling, I was able to free the tube from the dipstick hole. I have no idea what it was hung up on and it certainly sucked more time from my day than anticipated but it's done, oil and filter changed and ready to go again. Thanks for looking and...- My99Yukon
- Thread
- dipstick oil indicator
- Replies: 3
- Forum: Engine & Drivetrain
-
Gauges not at Zero with key off
When I was getting my fuel filter replaced after the last attempted filter change and fuel spillage (See my fuel filter fiasco thread here) , the tech pointed out that the gauges still seemed to have power and still registering data from the sensors, ie fuel, oil pressure, temp but not the... -
Fuel flowing during filter change
After my MPFI Conversion, I decided it would be good to also change the fuel filter. I have done this before with minimal mess and spillage. This time, however, I had a very different result, despite the fact that I had bled the pressure from the system during the MPFI install. I went through...- My99Yukon
- Thread
- Replies: 12
- Forum: Audio & Electronics
-
Fixing a failed fender trim
When I had my sliders installed, I asked the guy to bend/trim back the wheel well to fit the contour line so it matches up with the front corner of the slider. It made sense to me that by opening this lower arch opening I could put a slightly larger tire and avoid some of the potential rubbing... -
Project 99 Yukon
PROJECT 99 YUKON REHAB Hey All, I am new to the group and I am excited to see all of the cool builds and expertise on this forum. About Me: I have never wrenched on a vehicle but after a few hairy moments in my old 1999 Yukon with now 186K, it was either time to sell it or rehab it. This...- My99Yukon
- Thread
- Replies: 73
- Forum: Under Construction
Forum statistics
Latest posts
-
-
-
-
Rock Auto Discount Codes - Post 'em Here for Others to Use
- Latest: OR VietVet
