Search results

  1. S

    Front and rear brake job 2010 yukon denal

    Thank you! I will take a look at it later today.
  2. S

    Front and rear brake job 2010 yukon denal

    Hey guys, Very soon, I'll be helping a friend change his front and rear brakes/discs on his 2010 yukon denali. I couldnt seem to find a write-up other than one for a tahoe, which i assume should be the same. For peace of mind, do you guys have any suggestions or tips when doing this job? How...
  3. S

    rack & pinion and tie rod end advise

    So the truck belongs to one of my siblings. I asked him more about what the shop said. Apparently there is no leak, the "bellows" seem intact. They showed him how it works( moves left and right when turning steering wheel.) They didnt necessarily point out a broken/busted rack and pinon. They...
  4. S

    rack & pinion and tie rod end advise

    Hello! I'm not sure if this goes into Engine & Drivetrain. We were told a relative's yukon denali needs a new rack and pinion as well as outer tie rod ends. rack and pinion is busted and currently no point in getting an alignment. front outer tie rod ends seem to be "busted" as well. Inner...
  5. S

    My 2011 Yukon Denali Totaled Sunday Evening

    Damn those reckless drivers. I hope your little one has a speedy recovery.
  6. S

    Advice about buying a used Yukon to replace my 2003 SLT with 302,000 miles

    2010 yukon denali 6.2L comes with AFM.
  7. S

    loud ticking noise

    Luckily you have warranty. We had a case where a few lifters broke and fell into the camshaft. The "ticking" was loud at all speeds/rpm This happened in a yukon denali 2010 w/ about 60k miles. Unfortunately, the truck was out of warranty but had a chevrolet dealer fix it. It then happened again...
  8. S

    Anyone have blacked out stock halogen headlight assemblies?

    I doubt it. Driver bulb works but wont light up with passenger bulb. Fuses and relays work.
  9. S

    Anyone have blacked out stock halogen headlight assemblies?

    Went with these. They work fine for my brother. I dont know how they light up the road, though. Currently the truck has something wrong with the headlight wiring/ground/etc. on the driver side headlight. https://www.amazon.com/gp/product/B00OPBDKFM/ref=oh_aui_detailpage_o04_s00?ie=UTF8&psc=1
  10. S

    Any real "gains" from using cold air intake in yukon 6.2L?

    Okay, thanks! any difference in Low end Power? It seems that some reviews say there is a "slight decrease".
  11. S

    Any real "gains" from using cold air intake in yukon 6.2L?

    I will look into this.
  12. S

    Any real "gains" from using cold air intake in yukon 6.2L?

    https://www.amazon.com/71-3070-Blackhawk-Induction-Intake-System/dp/B00EQQIUGK/ref=sr_1_1?s=automotive&ie=UTF8&qid=1517337172&sr=1-1&keywords=k&n+71-3070+blackhawk+induction+intake+kit 2010 truck and it is stock. Would there be any difference in sound? or anything else in general? Also, it...
  13. S

    Driver side low beam doesnt turn on.

    Fuses and relays are good. passenger side low beam works. Anyone have an idea why the driver side bulb doesnt turn on? already swapped bulbs and even have new bulb. thanks Btw, 2010 yuk denali
  14. S

    Another "service suspension system" message display.

    I apologize ahead of time if it has already been covered. 2010 yukon denali just had this message displayed. A few months ago, a mechanic mentioned something about a control arm being on its way or something along those lines. My questions. What would cause that "service suspension system" to...
  15. S

    Friday was a sad day RIP Avalanche

    That is unfortunate, but best thing is you and the wife are okay.
  16. S

    Tire issue

    This thread made my day! haha
  17. S

    SAMS club car battery for denali.

    Any Sams Club car battety recommendation for a 2010 denali with added amp/subwoofer. They have Duracell non AGM and AGM. Thanks
  18. S

    Switchback and load resistor installation question

    Thank you. I havent made a purchase nor looked at any particular brand, just yet.
  19. S

    Switchback and load resistor installation question

    Hello, i have installed load resistors in older cars without really caring about a "professional" look, only using electrical tape. They have all worked for years. Out of curiosity, what supplies do i need to tap the blue/white and black wires and have a "cleaner" look. Btw, if its not the...
  20. S

    Adding some HP and getting rid of DOD

    Wow!
  21. S

    White smoke at start up after a 2 hour trip.

    Just curious, what is a safe oil pressure range?
  22. S

    Anyone have blacked out stock halogen headlight assemblies?

    Here is a pic of what i was looking for, just in case some else is curious.
  23. S

    What did you do to your NNBS GMT900 Tahoe/Yukon Today?

    rtv silicone or something else you recommend?
  24. S

    Inexpensive tune?

    Same, found a shop/tuner in downey, california that disables afm for $100. Street tunes are start around $300
  25. S

    What did you do to your NNBS GMT900 Tahoe/Yukon Today?

    Link? Have you had any moisture creep in? Clear pealing on the outside? My brother wants to get some of those. He doesnt want to retrofit, anytime soon.

Forum statistics

Threads
129,192
Posts
1,811,947
Members
92,295
Latest member
pikelk98

Latest posts

Top