Search results
-
Mystery Oil Leak
My last check was passenger side and seems to be slightly above/around the starter. I thought it was the oil plug...no. I saw a few drops come down when I wiped things clean then started the truck to try to take a look. Geotrash noted the valve gasket but I 'think'...again my opinion... I would...- Koop
- Post #50
- Forum: Engine & Drivetrain
-
Mystery Oil Leak
Appreciate the feedback. I did the rear main seal 'hand/visual' check and that was bone dry after replacing the block-off plate on the driver side but as I have read here there is no ' true' way to gauge this unless I snake a camera up in there. Is this the driver-side valve gasket you're...- Koop
- Post #48
- Forum: Engine & Drivetrain
-
Complete audio overhaul/replacement (install thread)
I second this question... could you share if you purchased the hvac control unit elsewhere?- Koop
- Post #11
- Forum: Audio & Electronics
-
Mystery Oil Leak
Hmmm going to check for the o ring. Is that on the passenger side? I replaced the block off plate and gasket above the filter which eliminated the leak on the driver side but now I am getting this mysterious leak on the passenger side. I have a 07 yukon denali xl and usually you can slide...- Koop
- Post #46
- Forum: Engine & Drivetrain
-
IMPORTANT: The Chronicles of Low Oil Pressure by 07burb
I will say thanks to @07Burb for this thread and everyone's contribution. I had this issue occur twice before just taking the initiative and just going about what is needed to be done; removing that damn filter. In my case I literally had to climb into the engine bay... everything else was a...- Koop
- Post #172
- Forum: Engine & Drivetrain
-
Backup camera + head unit install question
Just finished my Pioneer head unit, maestro RR, OEM camera until I find a nice quality aftermarket camera. Amp was added earlier with the lc7i. As headala stated.... the getting everything back in that dash was a pain (2007 Yunkon XL Denali). I had to adjust the inside compartment a bit...- Koop
- Post #5
- Forum: Audio & Electronics
-
When Did You Replace Your Ball Joints and Control Arms?
Go ahead and do you sway bar links and bushings fam. Those are 'easy' but annoying. You think your tie rod was a doozy... try those links on rust mode. I helped a friend with his and he never kept the maintenance. So trying to lock grip to go opposite directions to get them to break loose...- Koop
- Post #57
- Forum: Street Suspension
-
Odd noise from front end
Sounds familiar so here is my tale: 2007 yukon denali xl Sound was coming from driver side and definitely "Felt" like a vibration emitting from the area. Check wheels hubs... no play, hell both sides were new; check all areas of control arms, again new. Sway bar links and bushings... could...- Koop
- Post #9
- Forum: Street Suspension
-
Slight "thud" on moderate accel from standstill
Don't know if people are still answering but here was my issue: 2007 Yukon Denali XL AWD Thud noise when accelerating from stop or thud in decrease of speed in the lower range Once on a lift my uncle and I found that the issue was these mounts (differential): You can also inspect the...- Koop
- Post #55
- Forum: Engine & Drivetrain
-
Trouble shooting Stabilitrack and ABS
Late to the thread but let me put my ABS/Traction Control situation: Truck: 2007 Yukon Denali XL Both lights came on and stayed on after a long road trip from NYC. Luckily I have a mechanic by way of my uncle who had me replace both wheel hubs (front). Apparently, it is better to replace the...- Koop
- Post #11
- Forum: Engine & Drivetrain
-
service history from vin#?
Hey Drew can you run this vin number VIN number: 2007 Yukon Denali XL 1GKFK66827J148065 Thanks a million- Koop
- Post #122
- Forum: General Discussion
