Search results

  1. nate3531

    play in steering need help

    My 97 has a badly worn rag joint that I want to replace with a u-joint. Soon as I figure out how I will. I know on Pre-95 maybe 96 you can swap in a jeep steering shaft from an xj. Works great, I done in on an 89 I had. Loved it. Hope I can figure out how to do it on my 97.
  2. nate3531

    Help with Power door lock relay

    Well lets rule out that as the pigtail for the door lock relay, what do you suppose it is for? Maybe the remote keyless sensor module? Could the relay module pigtail be hidden somewhere in the dash? I really don't wanna take the whole dash out but I may have to. I really want these damn locks...
  3. nate3531

    Help with Power door lock relay

    Is it possible someone used a wiring harness from a pickup to replace the wires in my Tahoe or Chevrolet used the pickup harness on 2 door Tahoes in 97? If that's the case what is that relay I unplugged for and what is the part number to get a new one? I will double check but I'm sure I have...
  4. nate3531

    Help with Power door lock relay

    Ok I need some help. I am confused as to whether or not my Tahoe (1997 2 door) has a power door lock relay. There is a relay (was I lost it) in the exact location it should be, but mine is a 5 wire/terminal instead of a 6 wire/terminal. I got a relay from a 1998 4d Tahoe at the PnP but it is 6...
  5. nate3531

    Dome & Map lights

    Got an issue hope you guys can help with. I have no dome or map lights. So far I have checked the bulbs (seem fine) Metered the bulb connectors (no power) checked the fuse #14 (its fine) replaced it anyway (no luck) When I put a meter on the hot side of fuse #14 I get 0 volts. Checked it...
  6. nate3531

    Denali Console Sub

    Looks like a beefy build sub to be so small. I have seen 12's with smaller magnets :lol:
  7. nate3531

    Denali Console Sub

    That actually sounds exactly like what I want. Just to fill out the bottom sound stage so I can enjoy my music. I don't want or need earth shaking bass nor the loss of cargo that goes with that much sound. I may still build a console from scratch with a 10" sub unless I find one of these pretty...
  8. nate3531

    Denali Console Sub

    Actually I was asking for specs on the sub not the amp, when I mentioned the amp it was more of a statement than question. Sorry for the confusion. On the sub, what size is it, is it vented or sealed, up firing down firing sideways. Sorry I was not more specific with my questions the first...
  9. nate3531

    Denali Console Sub

    So you are using an aftermarket amp and the factory sub? Do you have any specs for the sub? Like how much power it needs and such
  10. nate3531

    2 door tahoe/blazer/yukon if you got one show it off

    Are 2 wheel drives allowed?
  11. nate3531

    Sub Box Ideas

    I have thought about that too, If I had the money to spend on materials for fiberglass experimentation I would try to build a box above the rear wheel. Do a 15" on each side
  12. nate3531

    Sub Box Ideas

    Are you working on a tight budget? if not have it done for you, probably be a couple hundred bucks but would be about as stealth as you can get. If your not in a hurry I will be building mine in a month or so, even if I don't have my subs just to have an arm rest that is functional...and I will...
  13. nate3531

    Sub Box Ideas

    What about removing the center console in the front between the bucket seats. That is what I plan to do. Build a box with the 10's downfiring and a padded arm rest on top.
  14. nate3531

    FNG checkin in

    This is the only good pic i have of her atm.
  15. nate3531

    FNG checkin in

    Howdy everyone, Name is Nate. Just found the site searching for an issue I have with my new (to me) 'hoe. I have always wanted a 2d 2wd and I found one about a week ago and snatched it up. She has a few issues, but I will work through them. :D Anyway, hope to use this site as a resource and...
Top