Bringing this thread back from the dead because I am very interested in this rear CV shaft you guys speak of. I have a 98 Tahoe with a RCX lift kit. Im using 5" lift blocks in the rear with a small shim. Not sure of the angle. Front is cranked so the truck sits level. I have the NP241 TC. I dont...
I have a 2 door Tahoe with a 6" RCX lift on it. Im running 5" blocks in the rear with the stock leaf springs. My springs are tired. Id like to replace them and eliminate the block and go with a new spring that offers some extra lift and possibly do the shackle flip. Just not sure about how well...
Have you checked the voltage at the pump? An under powered pump will not last long. Check the output voltage at the relay. Check it at the rear near the tank as well.
Couple more things Id like to add.
check the heater core and the box and look for debris buildup on the core. There are youtube videos on how to clean it out.
Check the condenser for debris. Clean with pressurized water and a cleaning solution
also check the high and low pressure (PSI) of...
Why did you choose to use the 454SS steering box? I think its a quick ratio box. Maybe going to a stock type unit for your truck would help reduce the steering response a bit??
A few years ago, I did a RCX lift on my 98 Tahoe. I found a crossover pipe that worked perfect with the OEM exhaust allowing me to reinstall the front shaft. I will be installing a new Magnaflow dual cat ypipe this weekend and would like to replace that crossover pipe but I cannot for the life...
I picked up a used 241 from a junkyard last summer for $125. I replaced all the seals and bearings in it for another #150 or so and it was back in my truck in about 2 hours. They are extremely easy to rebuild. There isnt much inside them
Awesome thread. Hows has the truck been running for you?
Id like to do this same swap in my 98 2 door. I think my biggest area of confusion will be the wiring. What did you do and use for the wiring change over?
Do you have a lost of parts with part numbers for all fuel fittings and sensor...
Its an OBS style from a 99. The floor vents under the dash on the trans tunnel not push air directly into the center console trapping it which isnt very effective. I can put my hand over the cup holders and feel cool air slowly pushing out when the A/C is on.
I want to know if GM used a...
I used an epoxy from a company called West System.
The white stuff on the bezel is a plastic JB Weld filler. I then used the epoxy to hold it all together from both the front and back sides. The epoxy was too watery to be used to fill gaps which is why I used the white stuff.
Sent from my...
does anyone know if the Denali console has a special adapter for the duct work under the center of the dash? almost all of the airflow from lower center vent goes directly into the console now.
Here are a few pics of my DD installed in my 98. I made a custom bezel opening by using two OEM bezels. I lowered the HVAC control and did some minor trimming and grinding inside the stock radio opening. It took a some time but wasnt too bad. I had the inner part of the bezel hydrodipped in...
You said in an earlier post that on those owners who have the auto 4wd should use the blue fluid. I have the manual floor shifter and you suggested I use the blue fluid. Which is it now????
Sent from my piece of crap iPhone using Tapatalk
I bought the light from Rigid Industries. It puts out 19k lumens. It is their 30"E2 series in Combo.
I'll try to get some night pics when I can.
Sent from my piece of crap iPhone using Tapatalk
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.