Resistors will be spliced in tomorrow or Monday evening. Went with the Bilstein 5100 and put new moog coils in the rear. I would recommend them 100% So much better than what the z55 had degraded to.
Hello one of my dogs had a good time under my truck chewing up some stuff under my truck the other night. New abs control module and wiring has been fixed $$$$! Now on to the hose for the rear fluid. Does any one have a diagram or tips on the routing of the hose? I have the part and would like...
Any tips on a popping sound from fro t right suspension. Not sure how long it’s been going on since it’s my wife’s Yukon. The popping occurs sometimes when turning hard left and reversing. To me it sounds like a tire rubbing when oversized. Factory wheels and tire size though. I replaced them...
When the station first opened the particular pumps were labeled flex fuel on a orange sticker now I am pretty sure it says E 88. I’ll swing by tomorrow and post a pic. My Yukon is a 2007 so it’s ok for it. However didn’t know if it would matter to suddenly swap after 10+ years of normal gas.
So I have never used and ethanol gas because of no availability. However a new station opened nearby with the 88 blend. Is it ok to start using some now? 130K mileage.
So its been a while since this thread was active. Has anyone figured out if the auto-ride level sensors will need a resistor if they are disconnected? Not even sure if I need to disconnect if not planning a lift or drop that the would need to be unplugged. Just looking to bypass the z55 option...
Hope this is in correct section as its not lowered or lifted.
Have a 2007 yukon xl 1500 with autoride and looking to replace front shocks with oem function.
Just wanted to make sure ac delco part # 580-372 or part # 20810269
would be the correct part.
Thanks
Been a month or two since I purchased a 07 yukon xl. Just now getting around to setting up the onstar. However the people at onstar says my yukon is not sending info to them and want me to take it in to the dealer, but can talk to them via onstar. Any one have any suggestions on what may be...
My 06 silver had same message and ended up being sensor connector. Looked like wife or friends had kicked a few time under seat and wire was loose. Just soldered back and back to normal.
Stock muffler back cut off then weld on Magnaflow 12589 muffler. Then dump right before or after axle. Think drone in cabin will happen or if exhaust will make its way into cabin? Dont object to slp res. delete but rather so no tips at all.
As soon as I get home I will pop the one off that I have.
that part earlier in titanium is 15279671
http://parts.nalleygmc.com/images/parts/gm/fullsize/071024TC16-458.JPG
---------- Post added at 05:24 PM ---------- Previous post was at 05:05 PM ----------
15279691 for titanium and...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.