Did some more tinkering with mine to get it how I want it! Installed footwell lights on my 04 suburban, installed the LED diode mod so that I don’t have dim map/cargo/vanity lights, added a 3/4” rear coil spacer to correct the driver side lean, and tightened my parking brake cable by adding a...
Also curious if anyone has a solution for the driver side lean. Mine is about 3/4” lower on the driver side front and rear measured from the fenders. I saw another forum someone mentioned replacing the swaybar links helped which did nothing for me. Might just add a 3/4” spacer on the rear left...
Thank you for this, I found out my permatex glue is not conductive. If I hold a small wire directly from the tab to the copper grid lines I can feel it’s start to warm up almost immediately. Time to redo this with a silver epoxy, don’t want to risk shattering the window with solder.
So after days of searching I can’t seem to find a solution. I have a 2004 Suburban Z71, recently purchased, and on the tailgate the driver side defogger tab was broken off the window. So I buy the permatex tab glue, glue it back on and it is rock solid. I then go to turn on my defoggers and bam...
My bad I didn’t update earlier, I got it out!! I separated the tie Rod from the knuckle so I could turn the knuckle left as much as possible, and loosely connected the slide hammer. Not 30 seconds later with two dozen good wacks and it popped right out. Got the new seal in and so far so good...
An update for everyone- it is my stub axle seal. I replaced the diff fluid and that made it very obvious what the problem is. I now have my CV removed and trying to remove my driver front stub axle and I cannot for the life of me get it removed. It’s been about 3 hours of using pry bars/...
Hey all, I bought some auto trak 2 fluid for my t-case but the bottle is something I’ve never seen before. Got this off of Amazon. Is this a new bottle? I’m thinking it’s a fake. Front and back pics attached.
Yes from reading before I posted this thread all signs pointed to that seal, however since my front diff fluid is completely full I ruled that out. Maybe it leaked and was fixed by the previous owner and a non-issue? I recently went down a very dusty road and no dust stuck on this grease to show...
I checked around the area. Don’t see any obvious signs of leaks. The hydroboost area is spotless, I have some gunk residue below the power steering fluid cap but it looks like that’s just from filling it and spilling an ounce. The ps fluid level is a little low- it was still on the dipstick but...
I have a 2004 Suburban Z71, and noticed a leak of some sort at my drivers side CV where it bolts to the axle. It’s on both sides of this flange, and doesn’t seem fresh- it’s dried out, and caked on there good. I also checked my front axle fluid and it’s so full it came running out the full bolt...
It’s been in NM and CO it’s whole life, not a spec of body rust. The frame wax has worn off and has some minor surface rust so planning on fluid film to prevent any further damage. Here’s some more pics too-
Hey all, my name is Alec and I’m excited I finally have a Suburban! They’ve been on my radar for a few years as a large road trip/overlanding rig after having a few 4runners and Isuzu Troopers. Picked up a mint condition 2004 Z71 with only 83k miles locally, and it’s already got some camping...
Hey all, first post here! Wondering if someone has the width of the 2nd row bench seat and then also separate width dimensions of just the “40” part and just the “60” part? Trying to figure out if a bench would work better than my captain seats for storage options. Thanks
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.