I put it in the air and found nothing obvious. This is a rear wheel 2wd truck so no front CV axles. All ball joints look fine. There is a little play in the bearing when I move the tires side to side but it's very small. Here is a video of what is happening around 12mph and the truck starts...
I can see the front end move while driving.
Front end makes no noises while this happens. I have done no recent work to the suspension or tires. This happens while driving straight at 10mph to 15mph and is very noticeable like the front tire might come off. Once at higher speeds it does not do...
@kbuskill Thats what happened to mine and is the reason for installing a new one, installing a new canister and blowing the lines out when I also changed the fuel pump.
Is it normal for the fuel pressure sensor values to go up and down. I connected my scanner and recorded the pressure requested, pressure sensor voltage and pressure sensor pressure while driving. While cold 57 here this morning and before the truck was warm the values were up and down from...
@Doubeleive First we all have to remember this truck is my wife's 99.9% she is driving it and what she sees and tells me won't be as thorough as what we would see and look for. This time when this truck stalled on her in the parking lot it sounds very much like when my Dodge Ram 5.7 1500 stalls...
@Joseph Garcia I tested the pressure while sitting in my driveway and not driving around. The pressure in park and turn the key to on but not start is 58 (prime). The pressure when the key is turned to start in park goes up to 60 and then as idle drops to normal 600rpm the pressure is 43psi...
@SpareParts No Sir the problems with this truck started before I installed the AFM disable. The AFM disable install was an attempt to isolate this problem by preventing the engine from shifting back and forth from 8cyl to 4cyl at low speeds where I'm having this surging problem. But then it...
@j91z28d1 replying to your thoughts and thank you for the input. I installed a brand new OEM negative battery cable set and cleaned all connections. No issues filling the tank and I did replace the EVAP purge solenoid and tested it good. MAF sensor is bran new and looks to be working normally on...
I tested fuel pressure and fuel trim at idle and at 2000rpm:
FUEL TRIMS: Look normal and so do the O2 sensors.
IDLE
STFT BK 1 0 to 6
STFT BK 2 0 to 6
LTFT BK 1 1
LTFT BK 2 1
2000 RPM
STFT BK 1 -3 to 2
STFT BK 2 -3 to 2
LTFT BK 1 0
LTFT BK 2 1
Fuel...
I placed a fuel pressure gauge on this truck and it tested at 43psi at idle. I'm told that's normal for a FLEX fuel engine. All last week this truck drove just fine every day. Yesterday after sitting all night it was driven about 50 miles with no problem. My wife parked and went inside a store...
2012 Yukon Denali 6.2L 6L80E 171000 miles.
I have been driving this truck for over a week with no problems at all. Wife drove it 40 miles one way with no problems. On her way back after driving about 10 miles she stopped at a store. She started the truck and backed out of the parking spot and...
@donjetman and @NickTransmissions
Would the pressure test show the faults donjetman shows in his video link? If I had the same problem would my pressures have been different?
@NickTransmissions and @donjetman
Would the problem donjetman describes and provided great photos for show up while pressure testing the 6L80E transmission with a gauge?
@NickTransmissions I was going through TSBs for my truck and found one that describes what mine is doing but it says the TSB is for 5.3 engine instead of like mine which is 6.2.
Vehicle owners may report a flare—an engine rpm increase during the shift—when the transmission shifts from 2nd to...
I just pressure tested my 6L80E with a mechanical gauge screwed to the line pressure test port on the passenger side next to the bell housing. (7/16 bolt). Engine at normal temp of 210F. @NickTransmissions
P R N D M M2 M3 M4 M5 M6
IDLE...
I'm in southeast GA. If somehow I were to need a 6L80E transmission or rebuilt one?
I have rebuilt engines and TH350 transmissions. Is rebuilding the 6L80E something I can rebuild myself?
What rebuild kit would you recommend as there are so many out there including EBAY and AMAZON etc?
I know...
@NickTransmissions Good morning Sir! Subscribed to your YOUTUBE channel by the way and please don't get rid of it. I drove this truck again this morning and nothing happened as it drove normally and now that the engine is warm it will be fine. My problem happens at low speed randomly when the...
Looking for anyone else out there using this engine and transmission having similar problems. 170000 miles on mine. I have searched the internet and cannot find anything. This problem throws no codes or check engine and is random. For instance mine went 9 days without a problem and then one...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.