Search results

  1. donjetman

    Mods Because Of Social Distancing

    How's that workin out for ya now :(
  2. donjetman

    Mods Because Of Social Distancing

    man were you wrong:(
  3. donjetman

    Easiest way to install manifold clamps? Dorman Manifold clamps

    Pay someone BIG$ to do it or https://www.tahoeyukonforum.com/threads/lifter-tick-when-cold-berryman-b12.120184/page-2#post-1469315
  4. donjetman

    Transmission fluid exchange...an anecdotal experience

    My 6L80e holds 3 gals.
  5. donjetman

    My 07 Denali XL 'build'/Check Engine Lights/Questions

    I did 3 of the 4 corners of my 07 6.2L 4+ yrs ago with: https://www.tahoeyukonforum.com/threads/lifter-tick-when-cold-berryman-b12.120184/page-2#post-1469315
  6. donjetman

    07 denali engine oil pan gasket

    Relief valve, I put a GM shield ($7) on mine.
  7. donjetman

    Replacing torque converter - with what?

    Yes, the 4646 is stronger is what the dealer told me that I purchased it from.
  8. donjetman

    Replacing torque converter - with what?

    I installed a Precision of New Hampton tc, # P4646, 4+ yrs and 57k miles ago when at 132k miles I had my tranny etc out to do a rear main seal job. $218 and no regrets. https://gopnh.com/
  9. donjetman

    That's it - F this turd-burban.

    12.3v is about 60% charged
  10. donjetman

    Throttle body cleaning for 2014 Tahoe LT

    Yeah, the socket is needed
  11. donjetman

    Throttle body cleaning for 2014 Tahoe LT

    See my signature below?
  12. donjetman

    Throttle body cleaning for 2014 Tahoe LT

    I clean my throttle body and have never had to reset/relearn/scan or anything.
  13. donjetman

    Pulley question on 2014 Tahoe

    Back then I also installed a new amazon 160amp 8301N alternator and water pump, again still going strong
  14. donjetman

    Pulley question on 2014 Tahoe

    I changed all my belts, pulleys, tensioner from local NAPA 4 yrs & 55k miles ago and they're still going strong.
  15. donjetman

    '12 Denali AWD RH motor mount replacement

    Here's how I did it: https://www.tahoeyukonforum.com/threads/front-differential-mounts.120260/page-3#post-1676685
  16. donjetman

    Can't get intermediate steering shaft to separate from upper shaft

    I didn't disconnect the steering shaft. Here's how I did it: https://www.tahoeyukonforum.com/threads/front-differential-mounts.120260/page-3#post-1676685
  17. donjetman

    Another UOA = Used Oil Analysis, 07 Yukon Denali 6.2L w183k miles, Amsoil 0w-20 w/8.5k miles

    I bought a stock 02 C5 coupe, only 60k miles. Rides smooth and gets great gas mileage. Believe it or not? the C5 is gonna replace most of our Yukons trips of going back and fouth,1000 miles ea way, several times a yr between our 2 homes (TX & CO mtns). We no longer have large dog(s). We'll...
  18. donjetman

    Another UOA = Used Oil Analysis, 07 Yukon Denali 6.2L w183k miles, Amsoil 0w-20 w/8.5k miles

    no. My owners manual was written in 2007. A lot has changed since then, oils too. If crankshaft was shedding iron lead and copper from the bearing(s) would be thru the roof long before the iron from the crank shows up.
  19. donjetman

    Another UOA = Used Oil Analysis, 07 Yukon Denali 6.2L w183k miles, Amsoil 0w-20 w/8.5k miles

    The report in post#1 shows that the oil didn't shear. AWD and always properly inflated which helps me achieve the great reliability and gas mileage. as I stated in post#1 I changed all 4 recently I'm a light aircraft owner (25+ yrs) and a retired pro pilot. Iron was much higher in reports 3...
  20. donjetman

    2011 Suburban - Front end shakes

    I would never buy a driveshaft from a dealer. I've been having driveshafts built locally for 50 yrs without issue.
  21. donjetman

    Motor Oil Brand vs Consumption?

    ASTM D5800 - 08 Standard Test Method for Evaporation Loss of Lubricating Oils by the Noack Method. http://www.pqiamerica.com/Testdescriptions/Noack.html If one whats to know about "all things oil"? Bobistheoilguy forum
  22. donjetman

    2011 Suburban - Front end shakes

    Yes I had a brake hose colapse internally on me once, so when I do brake jobs I always replace the hoses too,
  23. donjetman

    Another UOA = Used Oil Analysis, 07 Yukon Denali 6.2L w183k miles, Amsoil 0w-20 w/8.5k miles

    steel/iron sleeves
  24. donjetman

    Another UOA = Used Oil Analysis, 07 Yukon Denali 6.2L w183k miles, Amsoil 0w-20 w/8.5k miles

    Engine suffered an overheat event (Broken heat hose plastic T) Dec of 2019, should have change oil immediately. Hi iron etc afterwards.
  25. donjetman

    2014 Yukon 6.2L lifter noise

    I installed a Precision brand # 4646 ($218) rebuilt TC in our Denali w/6L80 4+ yrs and 56k miles ago. Works great. https://gopnh.com/Torque-Converter-Specifications?AID=2574

Forum statistics

Threads
124,107
Posts
1,727,067
Members
85,682
Latest member
906962

Latest posts

Top