REF0603
Member
I guess I’ll have to find out lol. I can’t find anyone with that lift on the forum.
Lifted/Leveled 2021 - Postem Up
- Thread starter DWSmoot
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
ProfeZZor X
Full Access Member
I have the Ready-Lift 3" SST lift, and it's the right amount of lift for me without compromising parking garage clearances. with 33's and the 3" lift, my height comes in at around 6'6".
REF0603
Member
What’s the offset on those?? That’s a good looking Yukon. What’s kind of rubbing and trimming did you need to do?
Hunter Linn
TYF Newbie
Hey Guys,
I just ordered the RC 3.5" lift and 35x12.5x20 tires. I want to use it on my stock Z71 20" wheel. Do any of you know what size spacers I will need to prevent rubbing UCA, inner fender, ect. I do not want them to stick out far. Just enough to not rub.
I just ordered the RC 3.5" lift and 35x12.5x20 tires. I want to use it on my stock Z71 20" wheel. Do any of you know what size spacers I will need to prevent rubbing UCA, inner fender, ect. I do not want them to stick out far. Just enough to not rub.
STORMIN08
Full Access Member
- Joined
- Nov 21, 2011
- Posts
- 974
- Reaction score
- 459
i would do the thinnest bolt on specer you can get...1"
i have seen 1.5 and 2, both protrude more than i would care for. i like to mine to be covered by a STREET FLARE if needed, so no more that about 3/4" out of the fender.
i have seen 1.5 and 2, both protrude more than i would care for. i like to mine to be covered by a STREET FLARE if needed, so no more that about 3/4" out of the fender.
Hunter Linn
TYF Newbie
Thank you, I’ll go ahead and order that too. Hopefully I’ll have it all on in the next week or two.
nick14226
Full Access Member
- Joined
- Nov 22, 2019
- Posts
- 211
- Reaction score
- 210
Would check how deep the pockets are in the wheels you have, your studs are going to stick out a decent amount with 1” spacers (unless you’re willing to trim them).
I’m running 1.25” bora spacers and they clear but it’s close without stud trimming.
Hunter Linn
TYF Newbie
I was looking at running the 1.25" Bora spacers as well. It should fit. If it does not, I have no issue with trimming.
nick14226
Full Access Member
- Joined
- Nov 22, 2019
- Posts
- 211
- Reaction score
- 210
Last edited:
nick14226
Full Access Member
- Joined
- Nov 22, 2019
- Posts
- 211
- Reaction score
- 210
With that said I’m only talking the studs, only assuming the 1.25 are enough to clear UCA’s. And think you’re going to have a decent amount of fender work to fit 35’s.
Similar threads
