Yukon Denali Build
- Thread starter grantbgood
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
OP
OP
grantbgood
TYF Newbie
- Joined
- Jan 17, 2021
- Posts
- 25
- Reaction score
- 34
Thank you! Haven’t done too much too the inside yet, bought a set of weather tech floor mats and a iottie phone holder. Ignore the dirty ness of the inside it needs to be cleaned!
OP
OP
grantbgood
TYF Newbie
- Joined
- Jan 17, 2021
- Posts
- 25
- Reaction score
- 34
Replaced the low beams tonight so now all lights on the vehicle are 6000k. 1st picture is low beams and fogs. 2nd picture is lows and highs. 3rd picture is a comparison on the garage door. (Driver is 6000k and passenger is 4300k)
Short_Haul
Member
- Joined
- Jan 7, 2021
- Posts
- 49
- Reaction score
- 55
Lookin good! That light output is impressive! What tires are you planning on getting? And are you sticking with the 22’s or going smaller? Also did you install the lift yourself?
What did you use for aftermarket HIDs?
OP
OP
grantbgood
TYF Newbie
- Joined
- Jan 17, 2021
- Posts
- 25
- Reaction score
- 34
Thank you! I am still shopping around for tires looking at the different options available, I am thinking either all terrain or mud terrain tires. I am going to keep the 22” wheels and yes I installed the lift within a couple hours in my garage.
OP
OP
grantbgood
TYF Newbie
- Joined
- Jan 17, 2021
- Posts
- 25
- Reaction score
- 34
Torchbeam D3S HID Xenon Headlight Bulbs, 6000K Diamond White, 35W, High Low Beam, Replacement Bulbs with Metal Stents Base, for 12V Car, Pack of 2 https://www.amazon.com/dp/B07R1WT5XT/ref=cm_sw_r_cp_api_glc_fabc_CsHcGb7679QV3?_encoding=UTF8&psc=1
Mike Diaferio
Member
- Joined
- Jan 16, 2021
- Posts
- 32
- Reaction score
- 42
Nice looking ride. Like the color.
Looks great! I recently purchased the Suspension Maxx 2.5" leveling kit myself but have yet to install it. How high did you end up going in the front? Did you go with just 2" or did you go all the way to 2.5" and remove the UBJ to do so?
OP
OP
grantbgood
TYF Newbie
- Joined
- Jan 17, 2021
- Posts
- 25
- Reaction score
- 34
Thank you! I ended up going 2.5” by using 4 shims on each side, I had to loosen the upper ball joint but it was not too hard to do so. Just make sure to get a alignment afterwards my angles we’re adjusted pretty bad.
Similar threads
