I’ve never heard of ANY of these. Must be an East of the Rockies thing.
What did you do to your NNBS GMT900 Tahoe/Yukon Today?
- Thread starter phattyford
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
I’ve never heard of ANY of these. Must be an East of the Rockies thing.
Drok
Full Access Member
not to far east ive never heard of them either haha
Drok
Full Access Member
yup i have just slotted ones (not ps) and they rusted in the slots and when i hit the brakes it humms and has a lights vibration.
massivespl
I'm not mean, I'm honest.
got the floor and three doors done today. Going to start the last door and roof tomorrow. Used about 108sq ft so far
5strmtrp
Full Access Member
- Joined
- Jul 28, 2019
- Posts
- 365
- Reaction score
- 384
Pulled the headlights out, total bs that you have to loosen up the bumper to remove. Trying to figure out the wiring mess under the center stack disconnected a few extra power leads in various spots in the truck. Hell I posted it in the police section. She needs a good interior clean.
mikeyss
Full Access Member
Don't forget to get the top of those wheel wells and maybe a quarter of the way up the side wall under the window. That quarter panel is hollow inside with no way to fill it, at least block off the squares to keep the hollow tire noise out. I have also put more deadening on the floor where the 3rd row is, and it makes a big difference.
massivespl
I'm not mean, I'm honest.
this vehicle is getting a b pillar wall with six sundown xv2 12s on two vital power 700.1s. All holes will be filled with deadener and spray foam. I got some wood strips for the roof along with deadener. I got a few friends with some 160db+ vehicles
- Joined
- Jan 3, 2011
- Posts
- 49,909
- Reaction score
- 15,453
That thing gonna be a heavy sumbish! Lol
CaptainAmerica1
Full Access Member
I’m in Dallas. QT on every corner, BucEes is newer and bigger...
Chert_Detective
Supporting Member
- Joined
- May 4, 2017
- Posts
- 158
- Reaction score
- 428
I know everyone likes dirty/clean before and afters. Took my time, and a few beers, on doing the valley cover gasket and oil pressure sensor yesterday and today. All back together and running now but I did remember snap an after picture.
Similar threads
