George B
¯\_(ツ)_/¯
Maybe this has been covered but I can’t find it. When I press the button to try to pair my iPhone 8 to the bluetooth in my 2013 suburban I only get a beep after 2 seconds but no “ready” response. Any ideas?
No “ready” response when trying to pair to bluetooth.
- Thread starter George B
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
OP
OP
George B
¯\_(ツ)_/¯
I also noted no response when I push the buttons on the rear view other than the power button turns the green LED on and off.
OP
OP
George B
¯\_(ツ)_/¯
Manual says 2 seconds and at 2 seconds it beeps but doesn't say “ready”. I tried holding it longer but it makes no difference.
OP
OP
George B
¯\_(ツ)_/¯
Tried again this morning with no luck. Anyone else run into this before?
OP
OP
George B
¯\_(ツ)_/¯
OP
OP
George B
¯\_(ツ)_/¯
Anybody else have input or experience?
petethepug
Michael
Delete the info on your phone for GM BT. Use “pair phone” command with a different name spoken to the system.
I viewed a 90 sec video on YouTube that nailed it.
Sent from my iPhone using Tapatalk
I viewed a 90 sec video on YouTube that nailed it.
Sent from my iPhone using Tapatalk
OP
OP
George B
¯\_(ツ)_/¯
Still haven’t got this working. When I press the phone button I get a beep but nothing else.
