Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
Hope you're still around my man. One or more bulb pads along with some of the circuit traces have lifted from the circuit board. I switched from a medium to needle solder tip, and still no luck, my solder sucker or my solder wick pulled them up. Do you have any suggestions on repairing circuit traces on PCBs?
You can run jumper wires using some copper wires. Not exactly sure what you have going on, but just use some solder and a copper wire and jump it over to the good trace.
