ivin74
05 NBS Nali
This is how I did it,
Just like Mike said, separate the cup holder from the body like the picture below. I used the $9.99 rotary tool from Harbor Freight to do all the modding needed. It is time-consuming using the Harbor Freight tool, I suggest using a Dremel tool instead, it will be faster.
https://www.harborfreight.com/power...rotary-tools/rotary-tool-kit-80-pc-63235.html
Mark the long end 4-3/16" from the opposite end and cut thru the entire side. If the cut does not come out straight use a 12" file and file the cut until you get it straight.
Mark both ends 2-1/4" from the end you just cut and cut out to the edge of the cup holder. If the cut does not come out straight use the file and file the cut until you get it straight.
Just like Mike said, separate the cup holder from the body like the picture below. I used the $9.99 rotary tool from Harbor Freight to do all the modding needed. It is time-consuming using the Harbor Freight tool, I suggest using a Dremel tool instead, it will be faster.
https://www.harborfreight.com/power...rotary-tools/rotary-tool-kit-80-pc-63235.html
Mark the long end 4-3/16" from the opposite end and cut thru the entire side. If the cut does not come out straight use a 12" file and file the cut until you get it straight.
Mark both ends 2-1/4" from the end you just cut and cut out to the edge of the cup holder. If the cut does not come out straight use the file and file the cut until you get it straight.
Last edited:
