Melting standard volume/ pressure.
Tonyrodz's Tahoe Build Thread
- Thread starter Tonyrodz
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
that is interesting because mine is hi pressure hi volume (MEL-10355)
Yours is NNBS though, isn’t it? The NBS are recommended to use the standard pump unless there’s excessive engine wear. NBS generally run higher pressure at idle than NNBS. Mine was 40 at idle stock before the cam, roller rockers, supercharger, oil pump, etc.
Sam Harris
Supporting Member
Looking good! Yeah, sender was replaced recently, first non-ac-Delco, then 2-3 months later, with a Delco part lol. So really hoping it’s the stepper motor now.
Onebad1983
Resident Country Dumbass
- Joined
- Mar 5, 2018
- Posts
- 1,262
- Reaction score
- 1,128
Onebad1983
Resident Country Dumbass
- Joined
- Mar 5, 2018
- Posts
- 1,262
- Reaction score
- 1,128
Mine is around that at cruising speed
OP
OP
Tonyrodz
Resident Resident
It's a stock Esky cluster.God I need an aftermarket cluster
Onebad1983
Resident Country Dumbass
- Joined
- Mar 5, 2018
- Posts
- 1,262
- Reaction score
- 1,128
Still better than the ugly stock one
OP
OP
Tonyrodz
Resident Resident
Driving the Hoe today, it started running like shit, almost like it's missing--while in gear. Revved it in neutral and it sounded a little better. No codes, all plug wires look ok. I did put gas in yesterday and I'm wondering if I got some bad gas. BTW--still getting the reduced engine power, so cleaning the grounds and adding a new one didn't help.
Well shit.
Similar threads
