Recent content by Y2KpewterZ

  1. Y2KpewterZ

    Emissions stuff

    Vehicle is a 99 Yukon 5.7 4wd. Long story short bought the truck with a hole in the gas tank unbeknownst to me until I filled it up for the first time. No CEL for a massive evap leak though. Replaced tank and installed new Delphi pump and ACDelco tank pressure sensor. This caused new issues to...
  2. Y2KpewterZ

    What did you do to your OBS GMT400 Tahoe/Yukon Today?

    Sold my 2000 Z71 6 years ago. Been gmt400-less for that long. Picked this super clean 99 Yukon up Friday. Added BFGs, replaced a faulty brake light switch and added some led high beams today.
  3. Y2KpewterZ

    Progression of a well used 2000 Tahoe Z71

    Well, sold it tonight. 318k on the clock. Going home to its new owner in North Carolina.
  4. Y2KpewterZ

    my new (to me) Z71

    My old Z71... New Z71.. I sold my 02 F150 with the intentions on downsizing; sell F150, buy newer truck, then sell my Tahoe. I knew I wanted an either an 05-06 or 07+ Silverado crew cab short bed. Well after researching (and experiencing first hand on an "extended test drive") I didn't...
  5. Y2KpewterZ

    denali console and interior paint/dye

    Here's my refurbished console And the paints I used. I soaked all the plastic bits in SuperClean and used a metal scrubby to clean and remove all the crud, and finally cleaned with Dawn. I used the American Accents primer, and top coat in several light coats, and used the Fusion for...
  6. Y2KpewterZ

    What did you do to your OBS GMT400 Tahoe/Yukon Today?

    Refurbished this Denali console
  7. Y2KpewterZ

    Progression of a well used 2000 Tahoe Z71

    Mileage now at 312625 and still going strong. Just replaced original idler arm, idler arm bracket, pitman arm, and ball joints with Moog parts. Picked up a Esky/Nali console and refurbished it. Decided to keep this one, and sell the one that was in my truck because the rear cup holders...
  8. Y2KpewterZ

    OBS 99-00 Escalade center console

    Just pulled this 99-00 Escalade console out of my Tahoe. Its complete, but could stand to be refurbished. Rear cup holder is there but broke. Still has the Bose amp and CD changer in it. Fits 95+ Silverados, Sierras, Tahoes, Yukons and Suburbans. Don't want to ship, local pick up only. located...
  9. Y2KpewterZ

    driveshaft balance? or what?

    Been chasing down a wierd rattling noise on my Tahoe. I thought for sure it was a Ujoint.. Was playing in the snow a few days ago and smacked something underneath the truck on a curb. Ever since then I've been hearing it. So here's my question, are the rear shafts on these trucks internally...
  10. Y2KpewterZ

    What did you do to your OBS GMT400 Tahoe/Yukon Today?

    Cap, rotor, coil, plugs and wires.
  11. Y2KpewterZ

    under light load; engine misses

    Update: haven't gotten around to checking the spider injection. But it did receive a full tune up. The cap and rotor were pretty crudded up. Only difference in my part list was I used Delphi coil and cap. Engine runs smooth and the miss seems to have gone away.
  12. Y2KpewterZ

    under light load; engine misses

    The connector at the top.. The large rectangle behind the throttle body? The comparison of the old vs new in the thread posted, the old pic doesn't work.
  13. Y2KpewterZ

    What did you do to your OBS GMT400 Tahoe/Yukon Today?

    http://www.gmt400.com/forum/showthread.php?17168-How-To-Install-a-trans-temp-gauge-in-a-95-GMT400-with-a-4L60e
  14. Y2KpewterZ

    What did you do to your OBS GMT400 Tahoe/Yukon Today?

    installed trans temp gauge. well a few days ago...
  15. Y2KpewterZ

    under light load; engine misses

    I just replaced the cats in it this summer. Y pipe had a crack in it so I replaced it witha bolt on unit. Previous owner did intake gaskets on it already too. Not sure if spider injection was upgraded or not.. Any way to tell? Iirc if I take the throttle body off and look down, the lines will...

Forum statistics

Threads
129,209
Posts
1,812,208
Members
92,308
Latest member
madmax442
Top