-
-
Ttkdgirl replied to the thread Post rebuild issues.UPDATE: It was indeed a failing engine coolant temp sensor. Replaced it, cleared the codes, works perfectly fine now. Thank you all for...
-
Ttkdgirl replied to the thread Post rebuild issues.I suspect you're right. Now that the ECT is off, it starts just fine. Where is this located on the 2011 denali? Think I might be able to...
-
TIf the engine coolant temp (ECT) sensor is not reporting properly, or there's something wrong with the circuit, that could very well be...
-
Ttkdgirl replied to the thread Post rebuild issues.And this just happened..WTF is going on. Is it time to get rid of the tune?
-
-
Ttkdgirl replied to the thread Post rebuild issues.Thank you for the offer! I'm way up here in Michigan. :)
-
Ttkdgirl replied to the thread Post rebuild issues.Did everything you outlined. It started but very slow and once it did start, the idle was very rough and the car shook a bit.
-
THas it run an evap drive cycle, or have the codes been recently cleared? Had any prior trouble with the evap system? I'm with @iamdub...
-
Ttkdgirl replied to the thread Post rebuild issues.2011 Denali XL with Flex Fuel
-
Ttkdgirl replied to the thread Post rebuild issues.The first method, no turn over. Just crank. All dash lights on. It did not stop on its own, BTW. Released the pedal, turned back on and...
-
Ttkdgirl replied to the thread Post rebuild issues.Will give this a try in a bit, thanks!
-
Ttkdgirl replied to the thread Post rebuild issues.Not that it means anything but I ran Torque Pro and here are the results. Everything was ok except all the EVAP stuff. I also ran the...
-
-
Ttkdgirl replied to the thread Post rebuild issues.Every single light on the dash turns on when it cranks but doesn't turn over.
-
TIf all that was working before the rebuild then you begin to wonder if everything was installed and hooked up correctly. It may end up...
-
Tthat's where I'm at.. I put a new napa pump in my 96 and probably 6 months after doing it, it would crank for a while before starting...
-
Ttkdgirl replied to the thread Post rebuild issues.It does not. Tried the 3 sec/5 sec this morning and it wouldn't turn over (start). Came back 5 min later and it started right up.
-
-
Loading…
-
Loading…
