Recent content by Th8nos

  1. T

    Add 4wd harness

    Thnks . Its going in my 2dr hoe. I did have the 5.7 in it but my buddy gave me a sweet deal on the 5.3 and ecm.
  2. T

    Add 4wd harness

    I've went a different route with the engine on my 2dr Tahoe/ Esky swap. I'm running a 5.3 out of an 03 Yukon and mating it to the 4l60 4wd from my 00 escalade. I have the ecm and my harness is an aftermarket stand alone. My question is; how can I tie in my 4wd wiring to the new stand alone? I'm...
  3. T

    No crank or start

    The donor was driving perfect. It was my 98 4dr. During the swap I've replaced the distributor, ignition coil, plugs, wires, O2 sensors, crank sensor, starter, oil sensor, ignition switch and lock cylinder, all new. That's why I'm so lost to what could've happened. I even got a new battery and...
  4. T

    No crank or start

    Yes that is correct.
  5. T

    No crank or start

    I've checked all the fuses and relays and they're fine. I'm getting voltage from the purple wire at the neutral safety switch when I turn the key to run. The switch is new and aligned properly. Would the 3in body spacers cause a no ground effect? When I checked for ground at the core support...
  6. T

    No crank or start

    I just bought a 98 2dr Tahoe, now here's my situation. It has a 3in body lift, I installed the motor and transmission along with the computer, harness and connectors. I also replaced all sensors, pnps, starter, new battery, etc. Now when I go to crank it, it doesn't do anything but it has power...
  7. T

    Door lock inversion module and headlamp control module

    I'm having a very difficult time trying to find the door lock inversion module and headlamp control module for a 99 Yukon Denali. I have all the wiring diagrams and the location on where it "should" be but I see nothing. To start off with I've done the obs swap and I think I moved too quick on...
  8. T

    Running woes

    I know this is old but I just gotten back to my truck. OK here goes; I've got everything wired up also with a push start alarm system. I can crank it if I jump the relay but not start. Its getting fuel no problem. If I put it in neutral it will crank from the switch but not start. I have no...
  9. T

    Running woes

    Yes. I was driving it to make sure everything was done before the swap. Everything was fine that's why I'm kinda confused on why it's acting up now
  10. T

    Running woes

    It's a non chipped key ignition but it does have the pass lock. The magnetic piece on the key tumbler. The security light does stay on. What is strange is that during the swap I've left everything connected except when I unplugged the ecm and bulkhead connector.
  11. T

    Running woes

    Thanks doc5339. I've replaced all three before I dropped it in the Tahoe. The dlc says no communication turn on ignition
  12. T

    Running woes

    I have a 95 2dr tahoe that I've upgraded with a 2000 escalade. Everything from engine/trans, ecm, bcm, harness, dash and steering column/wheel. Now i can't get it to crank unless I jump the starter relay. Nothing from the key except a click from the tccm and thats it. Can someone help me out...

Forum statistics

Threads
128,790
Posts
1,805,502
Members
91,773
Latest member
wbhidalgo17
Top