-
-
Shadowz Edge replied to the thread What did you do to your NBS GMT800 Tahoe/Yukon Today?.Repair failed. Looks like I get to pull the entire door harness out and go through the wires one by one. -
Shadowz Edge replied to the thread What did you do to your NBS GMT800 Tahoe/Yukon Today?.I figured out how to take apart that connector and now I get to attempt later on of soldering a new wire extension to reconnect back to...
-
-
Shadowz Edge reacted to ScottyBoy's post in the thread What did you do to your NBS GMT800 Tahoe/Yukon Today? with
Like.
Correct. I've had to repair broken wires inside the rubber door jamb boot. Due to the flexing of the door opening and closing, I had... -
Shadowz Edge reacted to Fless's post in the thread What did you do to your NBS GMT800 Tahoe/Yukon Today? with Like.
When you do this, don't try to remove that driver's door module (DDM) without pulling the door panel. There is a screw holding it in...
-
Shadowz Edge reacted to ncalvo's post in the thread What did you do to your NBS GMT800 Tahoe/Yukon Today? with Like.
Hmm I might have to try this. My driver side door lock button doesn't work and I haven't located where the issue is yet
-
Shadowz Edge reacted to ScottyBoy's post in the thread What did you do to your NBS GMT800 Tahoe/Yukon Today? with Like.
Worst case scenario, if you can't repair that wire. You could always go cut that plug off a donor truck in the junkyard, and just...
-
Shadowz Edge reacted to bodabdan's post in the thread What did you do to your NBS GMT800 Tahoe/Yukon Today? with Like.
https://a.co/d/a0j2ZlH I have one of these kits, definitely worth having around.
-
Shadowz Edge reacted to Keviebear86's post in the thread What did you do to your NBS GMT800 Tahoe/Yukon Today? with Like.
Cheddar Burb! You know, like Cheddar Bob!?!?
-
Shadowz Edge reacted to Fless's post in the thread What did you do to your NBS GMT800 Tahoe/Yukon Today? with Like.
Probably going to have to disassemble the connector shell, de-pin that broken wire, and solder a longer wire to the pin so you have...
-
Shadowz Edge replied to the thread What did you do to your NBS GMT800 Tahoe/Yukon Today?.That's what I'm thinking as well ... Just need to figure out how to dismantle the connector
-
Shadowz Edge replied to the thread What did you do to your NBS GMT800 Tahoe/Yukon Today?.Like it looks like a block of mild Cheddar cheese and it's going to take me a bit of Cheddar (money) to get good again lol
-
Shadowz Edge replied to the thread What did you do to your NBS GMT800 Tahoe/Yukon Today?.I pulled off the driver's door panel to get at the electrical I knew I had to fix but I didn't think the broken wire was going to be...
-
-
Shadowz Edge replied to the thread What did you do to your NBS GMT800 Tahoe/Yukon Today?.Old school district vehicle actually
-
Shadowz Edge replied to the thread What did you do to your NBS GMT800 Tahoe/Yukon Today?.I bought mine ... I've named it Cheddar
-
-
Shadowz Edge replied to the thread Are the locks the same?.One of my other plans is to also get new fobs as well. Do you know if all the locks are the same part number between the Barn Door and...
-
-
Loading…
-
Loading…
