I have found a donor truck for an entire brand new interior for my SLT and it comes with factory heated seats my truck does not have heated seats from factory. I'm grabbing pretty much the entire interior minus the headliner and the rear quarter panel trim pieces. The new door panels have...
I have the gold/tan interior package and I cannot find the front seat back panels. All the clips are broken therefore not allowing it to be reinstalled. My seats are just bare foam on the back. I'm looking for somewhere I can buy replacements. Anywhere I look they are either different types or...
I had to remove my fuse box to access something else and in the process the two clips broke while removal. I'm trying to find out the part number I've search up a bunch but have only found the full fuse box.
I have an 09 Yukon that I'm about to be putting a 16 volt bank. I've already received my bank and alternator. I'm looking for a way to have my second alternator go to my lithium bank apart from the 12volt system. I'm wanting to put a relay in at the alternator I just need a diagram or something...
UPDATE: I have lean codes now for both banks. I am looking for some sort of help getting this tuner set up for my needs. I have a 2009 yukon 5.3 with a Spectre cold air intake and a Diablo intune 3. I had some problems with the intake before so I had to remove it until I could get a tune. Now...
The dangling hose is the hose from the old valve whenever they disconnected the old one to replace it they never removed the old hose and the new vent line is just zip tied next to the factory one.
I just climbed under the vehicle to inspect the vent valve and it looks like it has already been replaced with a new one because I can see the brand new hose that goes up by the gas cap already attached and the old one is hanging down. I also replaced the valve right by the intake and it looked...
the shop that I have taken it to multiple times have told me that they have used the smoke tester on it more than once I have not been able to find anything
I have a 2009 Yukon 5.3 fuel flex.
I had it taken to a shop because of a code for small evap leak upon taking it to the shop they used a smoke tester on it and were unable to find anything, I have replaced the purge valve by the intake, I have checked my gas cap as well. I'm trying to find a...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.