Hi All - I am going to replace the rear driver side seatbelt. Please share any inputs and order on safely removing the trim shown in picture to reach the seat belt? Also, should I remove the bolt seen deep inside in the circled hole on the trim? couldn't find any YouTube video or post regarding...
I have the same issue, did you end up changing the seat belts or the buckle ends? I am planning to change the seat belt to match with the seat and the buckle end.
Hi All - Bought a old bike rack like in this picture, but the one I purchased did not come with hitch pin. https://images.offerup.com/UAZC-vobsFxy4jyqoawGupwrpoc=/612x816/photos/a438ba5d9214492ab915d01cf374e140.jpg
the bike rack has a square hole of size 3/8, while my Tahoe receiver has 5/8...
Hi All
I am trying to open below steering wheel fuse cover to do some parasitic draw testing. is it just pull of the lid or I have to take out the circle in the middle. just do not want to break any.
thanks
Hi All
Need help with identifying the part # of the nut fitting the bolt (circled in picture) which holds the wiring under sil plate, any alternative nut spec if known is fine as well.
thanks
:-)
I really appreciate it you taking picture for this and it was timely, I am relatively a newbie into automotive maintenance and still picked up this major (for me) project. so far so good, fixing headlamp and air intake box are the only pending stuff. hope I can finish today evening or...
I removed my fender for fixing a leak and I am putting it back. while removing, I removed the hood hinge spring bolt, now while putting it back, the hinge spring alone is not aligning as I believe it need to be compressed and fit, it is too tight and couldn't compress in position.
Am I doing...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.