Resistors will be spliced in tomorrow or Monday evening. Went with the Bilstein 5100 and put new moog coils in the rear. I would recommend them 100% So much better than what the z55 had degraded to.
Hello one of my dogs had a good time under my truck chewing up some stuff under my truck the other night. New abs control module and wiring has been fixed $$$$! Now on to the hose for the rear fluid. Does any one have a diagram or tips on the routing of the hose? I have the part and would like...
Any tips on a popping sound from fro t right suspension. Not sure how long it’s been going on since it’s my wife’s Yukon. The popping occurs sometimes when turning hard left and reversing. To me it sounds like a tire rubbing when oversized. Factory wheels and tire size though. I replaced them...
When the station first opened the particular pumps were labeled flex fuel on a orange sticker now I am pretty sure it says E 88. I’ll swing by tomorrow and post a pic. My Yukon is a 2007 so it’s ok for it. However didn’t know if it would matter to suddenly swap after 10+ years of normal gas.
So I have never used and ethanol gas because of no availability. However a new station opened nearby with the 88 blend. Is it ok to start using some now? 130K mileage.
So its been a while since this thread was active. Has anyone figured out if the auto-ride level sensors will need a resistor if they are disconnected? Not even sure if I need to disconnect if not planning a lift or drop that the would need to be unplugged. Just looking to bypass the z55 option...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.