What year did you use it on? My crankshaft is a double pulley. The tool i bought wouldnt go past timing cover if installed on back side of pulley. Also the a/c pulley is too wide and rounded in front.
Sent from my SM-T580 using Tapatalk
Yes no tensioner pulley on my '10. The tool doesnt work because 1. cant use on the ac compressor. 2. The tool hits a bolt at top of the crank pulley. I believe timing chain cover?
Sent from my SM-G960U using Tapatalk
Just changed my a/c belt this weekend. Its the elestic type with no tensioner. Took me a minute but finally figured it out. I bought a gates elestic belt tool to do the job. Long story short is...it doesnt work. Put belt behind crank shaft pulley, put belt on a/c compressor pulley, start belt on...
Just did upper and lower rad hoses on my '10 Hoe. Pulled lower let everything drain. Changed hoses and threw those damn factory clamps in the trash put old school clamps on. What a couple pos! Anyways put dex cool back in reservoir and let it warm up. Let cool for 15 min. Burped hoses...and...
Hello everyone! Forgive me if this already posted, but i'm new here. Should i flush the trans or just drop trans fluid and refill? Would like to hear everyones comments. Own '10 Tahoe 5.3L 4x4.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.