Recent content by Malik112099

  1. M

    2007 Denali whirring/whining noise with RPMs

    Hopefully the leak stop I poured in does the trick. I'll keep an eye on it tho. May just be time to replace it.
  2. M

    What did you do to your NNBS GMT900 Tahoe/Yukon Today?

    Just said various manufacturers on the rockauto site.
  3. M

    2007 Denali whirring/whining noise with RPMs

    Filled it up and the noise is completely gone. Drive into town and back and no signs of the noise. Not sure why I didn't think to check the power steering fluid before. Thanks for the help.
  4. M

    2007 Denali whirring/whining noise with RPMs

    This looks to be it. Reservoir is dry and of course I don't have any fluid. Running to the store.
  5. M

    2007 Denali whirring/whining noise with RPMs

    I had the tranny replaced a few years back and the shop told me the power steering pump was loud but nothing to worry about at the time. Maybe it is finally dying. I'll check the fluid level when i get home today. Might just call the car rental place and have them pick me up after dropping my...
  6. M

    2007 Denali whirring/whining noise with RPMs

    Replaced them a few weeks ago. Had no issues. Also it sounds the worse when first taking off as the RPMs climb. Doesn't seem to have anything to do with rolling speed.
  7. M

    2007 Denali whirring/whining noise with RPMs

    This whirring/whining noise (almost like you saying SHHHHHHHHH loudly) has been happening for a few days. It gets worse with RPM. Speed doesn't seem to affect it. No dash lights, no issues. Everything runs and feels fine other than the noise.
  8. M

    What did you do to your NNBS GMT900 Tahoe/Yukon Today?

    Swapped out the headlights and fog lights today. Think it woke up my sleepy truck a bit.
  9. M

    What did you do to your NNBS GMT900 Tahoe/Yukon Today?

    I had this happen for the first time a few months ago. I came back to my truck and the passenger side mirror had been manually folded by someone. No big deal as I've had to fold mirrors to back out before and I appreciate it over you just damaging it. When I hit the button to fold both in the...
  10. M

    What did you do to your NNBS GMT900 Tahoe/Yukon Today?

    When I bought my 07 in 17 both mirrors had broken gears and wouldn't fold. Opened them up and replaced the plastic gears and motors with gruven replacements. Been working fine since.
  11. M

    What did you do to your NNBS GMT900 Tahoe/Yukon Today?

    Pads and rotors today. Nothing special. Keeping her stock and humming along.
  12. M

    What did you do to your NNBS GMT900 Tahoe/Yukon Today?

    Plastic razor bladed and eraser wheeled the old 3M off my Yukon. Not bad for how old it is. Prepped the door molding with new 3M. I replaced the driver's side rear molding in 2017 when I bought it. Still holding up well. Gonna run it through the car wash tomorrow to clean off the eraser wheel...
  13. M

    What did you do to your NNBS GMT900 Tahoe/Yukon Today?

    I used this charger with a generic sticky dash mount that uses a universal 7mm ball mount.
  14. M

    What did you do to your NNBS GMT900 Tahoe/Yukon Today?

    Installed a magsafe mount/charger in my 07 yukon today.
  15. M

    Remote start disables power lift gate

    I use the power lift gate with remote start on my 2007 Yukon XL Denali. I remote start in the winter/summer as I'm walking out of the grocery store to get the heater/air running and then I use the lift gate to load groceries. Just to make sure I'm not crazy I just walked out, opened my garage...
See more

Forum statistics

Threads
129,120
Posts
1,810,776
Members
92,207
Latest member
2DoeProjectHoe

Latest posts

Top