Search the forums there is a better way by cutting and jumping some wires on the body control module behind the right rear panel. No codes or disconnecting fuses done it to mine about 4-5 years ago. Someone posted it on this forum from a gm dealer service manual. Then you can remove all of the...
Has any one changed the pitman arm seal/ steering out put shaft seal ? I bought the kit from gates. And disassembled the arm from the box removed the outer dust seal cleaned with brake cleaner but could not find the ends of the snap ring to remove. Any tips out advice on fixing this leak ?
I tried the fuse and still got the message also tried the resistor kit that did not work either. Do a internet search their is a body module plug in the right rear near the rear ac unit you have to cut a wire and jumper another. If I remember correctly someone posted it a while back it was in a...
I have a 06 lt with hydro boost all new rotors and pads (wagner) pedal is hard after the first 1/4 pedal. Have replaced master cylinder and hydro seals with no change think the power steering pump is has weak pressure have flushed the system still no change any suggestions ?
I have a 05 hoe with 5.3 and plan on doing some towing which shift kit should I be looking at ? I have already installed a second trans cooler and the corvette servo. I will do the install myself can I use a boost valve on this year ?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.