Recent content by Greg Kulbick

  1. Greg Kulbick

    Tahoe/Yukon Headlight Information Thread

    Anyone have some insight into some good housings that won't yellow. My wife drives my 07 that i put some new housings on a few years ago and the yellow lenses irk me. I feel like they get worse every time I come out of the garage. I'm not opposed to going to something with a projector and...
  2. Greg Kulbick

    HID to LED conversion

    I have factory projectors that came with halogen bulbs and switched to LEDs. That lasted about a month before I went to HIDs. Just find better bulbs.
  3. Greg Kulbick

    What did you do to your NNBS GMT900 Tahoe/Yukon Today?

    Any excuse to use Deadwood gifs.
  4. Greg Kulbick

    What did you do to your NNBS GMT900 Tahoe/Yukon Today?

    Replies above in red. Whatever this upgrade is, Tapatalk doesn't like it.
  5. Greg Kulbick

    What did you do to your NNBS GMT900 Tahoe/Yukon Today?

    Anyone have any tips for building more pressure in the lines to evacuate those stupid charcoal pellets without blowing connections off? Should I still try a fill with the tank to canister line disconnected? Also, when I blew out the purge line from the engine bay, I got pellets coming back out...
  6. Greg Kulbick

    What did you do to your NNBS GMT900 Tahoe/Yukon Today?

    Replaced the canister, purge solenoid and blew out the lines in the 07. Pump still shuts off, but at least fuel isn't being puked back out right now. Guessing I'm not getting enough pressure built up when I try to pump air into the tank, but it was spilling pellets.
  7. Greg Kulbick

    What did you do to your NNBS GMT900 Tahoe/Yukon Today?

    I checked everything while routing the replacement this evening and they all look good. One thing stood out to me, the shape of the new hard line to the canister from the solenoid was not able to follow the original routing over the top of the other lines. I had to go below them, but still well...
  8. Greg Kulbick

    What did you do to your NNBS GMT900 Tahoe/Yukon Today?

    Truck was off, tried going full blast at the pump and you could hear it gurgling then shut off, then some gas spilled out. Was able to get fuel in as long as I was deliberate with the handle. I'll get under there this weekend and pull the canister, give it a good shake.
  9. Greg Kulbick

    What did you do to your NNBS GMT900 Tahoe/Yukon Today?

    Replaced solenoid and used updated harness, no change. What's next, canister?
  10. Greg Kulbick

    What did you do to your NNBS GMT900 Tahoe/Yukon Today?

    Wife says the 07 spewed gas and isn't taking any in. Ordered the canister vent solenoid and updated harness. Going to take it up to the gas station tomorrow to see if I can coax some gas in there so she can drive it until the parts show up.
  11. Greg Kulbick

    2019 headlight help

    I went to LEDs on my 16 and it didn't take but a couple months before switching to HIDs. The light output is just exponentially better.
  12. Greg Kulbick

    Aftermarket wheels

    That's the stock tire size on your vehicle. You'll be fine unless the wheels you're looking at have some crazy backspacing.
  13. Greg Kulbick

    Not Sure If Your Rear Main Seal Is Leaking?

    Yeah, I know that set up. My days bench pressing transmissions into place are well behind me.
  14. Greg Kulbick

    Not Sure If Your Rear Main Seal Is Leaking?

    I was just under our Tahoe Friday night trying to clean up under there and pinpoint where the oil is coming from. I think the block off plate is fine. I didn't see much of anything when looking through the hole in the bellhousing, so I'm keeping my fingers crossed its just the pan gasket.
  15. Greg Kulbick

    What did you do to your 2015-2020 K2XX Tahoe/Yukon Today?

    Nothing big, just black bowtie on the rear and black lettering. Didn't realize until I started that the letters I got for the rear are the same size as the doors. Oh well.
See more

Forum statistics

Threads
129,127
Posts
1,810,874
Members
92,214
Latest member
George ramos

Latest posts

Top