I know what you mean about going higher than 4-5". I barely fit in my garage with the height that it is at. I was also able to due a tune for the larger tires too and noticed a big difference in shifting and pick up.
The only reason I went back to the torsion bars is the kit i got with the coilovers seemed very bouncy at low speeds. The only way i can describe it is when you see those rice burners going down the road and you see that slight bounce. It was annoying to say the least. But off road and...
Hey guys i know this is an old thread but i finally got the nelson performance wiring efan kit and the tyc 622230 fans along with the hp tuner. can anyone help me out on what setting to put the files at for the tune?
actually i was able to do it let me get some pics i got about 4 to 5 inch lift i think. my ride height from ground to bottom of fender is at 41" in the front and 40 in the back.
Ok cool so i can go with the 05 and up fan kit since i have the 34" radiator and the nelson wiring kit and get the hp tuner and tune myself? correct?
where do i get the firmware for the computer?
if i buy this will i be able to tune the computer to turn on the fans? sorry Im mechanically inclined on the vehicles but not when it comes to the computer stuff.
https://www.hptuners.com/mpvi2/
cool thanks for the info guys any suggestions on this reason im asking is not to try and do it the easy way it is because there is no one within 100 miles where i live to do the computer tune and the temps here are extremely high so idle sux we are usually a 99 degrees an higher pretty much til...
question on these efans can they be installed and use a radiator probe to turn on at certain temps? or does the computer have to be tuned no matter what?
well no one replied but i spoke to cody at bds suspension. He said ill prob get about a 5.5 inch lift in the front if i put leveling keys based on the photo i sent him since im still about 1.5 to 2inches from uca bump stop. Ill try to get it done this weekend and post pics if anyone is interested.
Looks good so far. Dont know if you mind letting me know what the height from floor or center of wheel to bottom of fender came out to. Also how angled your tie rods and ball joints ended up at? Thanks
Hey guys I need some advice or opinions and thoughts. I have an 01 Tahoe rwd that right now my current set up is coilover conversion in the front from atomicfab with 3" knuckles and z71 rear springs and running 275/60/20 on 20x9 with 4.5BS (33x11x20). It puts me at a ride height from ground to...
Right now i have these in the front of my 01 tahoe with z71 coil springs in back. very stiff ride great on highway travel but when doing about 30-55 you can feel a little bounce in the front. Ive messed with the rebound and compression rates since they are adjustable but a lot of bad roads...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.