Recent content by ChunkePPV

  1. ChunkePPV

    Check out my new PPV build

    this page has all the info you need, from what I remember its mostly red wires and a few red/white, the yellow plug with 2 wires is for the airbag in the seat. https://www.oemcarandtruckseats.com/blogs/knowledge-base/92612615-2007-2014-nnbs-chevy-gm-seat-swap-memory-bypass-heat-setup
  2. ChunkePPV

    Swapping my TBSS 24's

    Sweet I took your advice and went with a set of Defenders, I settled on 285/45/22's check it out let me know what you guys think.... I know she needs a wash lol
  3. ChunkePPV

    Check out my new PPV build

    its not too bad if you just want power to the seats, all the switches work when you pretty much all the hots to power, the tricky part is the serial bus line, its green, I think its on the passenger side, once both seats are connected to the serial bus line, the BCM can control them, ie for...
  4. ChunkePPV

    Swapping my TBSS 24's

    N+ññnm Thanks for the reply, I hope these michlens will ride better, but yeah if not I will have 30days to change them out, with discount tire. I don't know if you saw I changed out my front springs and put airbags on the rear, that definitely helped, but yeah at high way speeds I still feel...
  5. ChunkePPV

    Swapping my TBSS 24's

    I've been working on my suspension lately, trying to get that low, comfy ride. Swapped a ton of stuff, put in longer springs, drop spindles, softer shocks, even added airbags in the rear. It helped some, but man, after a long drive, I still feel like I've gone a few rounds in the ring. So...
  6. ChunkePPV

    Check out my new PPV build

    I also decided to work on the rear and add some airbags and replace the shocks for some that were softer
  7. ChunkePPV

    Check out my new PPV build

    Here's some after pics
  8. ChunkePPV

    Check out my new PPV build

    Hey guys, the ride quality has been driving me nuts and I did some digging and tried to find a way to get a better ride on the the Tahoe, looks like PPVs have 2 inch lower springs than the normal Tahoe, I like the low look and so I found a way to improve the ride and keep it low. It was a bit...
  9. ChunkePPV

    2014 PPV Seat Position Sensor wiring diagrams or Hack

    If the seat was disconnected and swapped with a diff seat, not original it will need to be zeroed out otherwise will throw error, the correct module from a different vehicle will need to be reset. If the swapped seats only got power and ground you would need to get a module in there connected...
  10. ChunkePPV

    Sooooooo, I bought a PPV ...

    Thanks a ton!
  11. ChunkePPV

    Sooooooo, I bought a PPV ...

    Hey long time, mr cranium, what part no was this steering wheel?
  12. ChunkePPV

    Adding air ride to 2014 PPV

    Anyway to add air ride to 2014 PPV? I have TBSS Wheels 285/40/24, and belltech 3/4 lowering kit. Could I plug in the escalade system in?
  13. ChunkePPV

    DIC switch

    Great post, what part number was that trim piece ?
  14. ChunkePPV

    Escalade seats in a PPV

    If all you wanted was motorized seats, they don't need the BCM or special wiring, just send the 12v in all the right places and it will work.
  15. ChunkePPV

    Escalade seats in a PPV

    Thanks for checking it out! Yeah it was a fun project, im still blown away every time I use it lol. First of all it's not very straightforward, I followed another build someone was working on and they had a slightly different model of seat and their wiring was different, so I suspect GM wires...
See more

Forum statistics

Threads
129,211
Posts
1,812,231
Members
92,310
Latest member
Ron505

Latest posts

Top