Looking for this pigtail to fix my bros abs codes . Can't find this pigtail anywhere. It's the circular one with the green. If anybody can help me out lmk.
Torque management is a 4l60s best friend no doubt. When the 60 in my hoe failed, wasn't a catastrophic failure I just started hearing some gnarly sounds coming from it, like a grinding noise when second gear engaged so I knew it was time to pull it before more damage would occur. Pulled it and...
Still a great deal. Got me back on the road and runnning QUICK. My old diff had 3.73 and my tahoe would take off like a rabbit. No complaints. Then again its an LS 2wd. Your z71 is 4wd a lot heavier.
I take that back. Won't be beating on it anymore. DAMN. With the 4.3. Did you remove TM on that 4.3? Were did the output shaft snap off? At the front planet?
I laugh at 4l60e's. They are so easy to rebuild. I can rebuild a 4l60/700r4 fairly quick. I have gotten really good at rebuilding them, theyre pretty simple transmissions. Can have one torn down and diagnosed in maybe 20 mins. Wouldn't call myself an expert but am fairly confident in my...
Hey thanks for all the info everybody. Got it installed few weeks go and have been driving it without any issues. Simply bought a spicer conversion u joint only 30$ (Spicer 5-3205x) and everything bolted right in. Only had to plug abs sensor holes and swap backing plates. Rear is quiet as can...
Dont have the cash for a rebuild or to hit the junkyard at the moment. Wouldnt have been much more money to get one at the junkyard but hey I took a chance on it. Got it for 100 bucks. Junkyard would have cost me like 250 not much more. I checked it out real good and conpared it to my diff and...
Hey everybody back again. Been a while since I posted about my trans rebuild. No surprise my diff started to take a shh shortly after the trans rebuild. I need help to figuire out if I can make this diff I picked up work with my 2003. Dude said it was off an 2012. I compared it to my diff and it...
My reverse drum is pretty damaged due to the bellville plate eating at the drum. How does everyone solve this problem? Even if you get a new drum it's still going to be putting metal into the oil over time. Cant seem to find the early wave steels used in 82-86 units or thicker frictions, can...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.