was it hard to paint those parts?
Absolutely not!!! Just remember to prep,prep,prep!!!! Can't state that enough. Use a prep spray, grease remover, hot water and soap. If your so inclined, sand that parts, but then use a wax remover. As far as paint, Krylon plastic paint works really well. Have used on many parts, in engine bay, with heat, with no peeling, chipping, yellowing, or anything bad happening. also, use a good clear coat, I like to use quite abit of clear coat to ensure a good top coat of protection. Other than that, just take your time, and don't rush painting. but again, paint is only as good as the prep work done before hand.
Separate names with a comma.