Show off your 2015+ leveled Tahoes and Yukons!

[gat0r]

@Ridechevy09 post that new hoe on 26x16! I saw these on the gram. Give us specs but looks like FTS 10" with coilovers, specialty forged 26x16 on Fury 37s.

not sure i quite grasp the metric offset crowd.
points for originality.


a buddies kid just put 28x16 w/ 42 tires on his f250.

 

[Demer]

Could you post a close up on the trimmed air dam?

Are these what you are looking for?

 

[Jenney72chevy]

Dumb question, have you tried going through a parking garage? My wife often goes to the city and into a parking garage every so often. This is the exact look I'm going for. Except my 'Hoe is Tungsten Metallic.

Jpritchie20 is the same vehicle and very similar look. Love y'all a rides.

I haven't needed to yet. I can take a measurement soon though of the overall height. I don't see a problem for Boston garages,it doesn't seem all that tall compared to other stuff I've done.

 

[bigT63]

Are these what you are looking for?

View attachment 182930 View attachment 182931

Very well done

 

[Demer]

Very well done

Thanks. I am really happy with the results. I cut off a lot, but now they line up just about perfectly with the running boards.

 

[Adam10532]

My '16 Denali XL with Fabtech 4" kit, 20x10 Fuel Tritons and 33x12.5 Fuel Gripper M/T's.

View attachment 69564[/Quote I have the same lift and man it looks bad my front end is low what gives that looks great did you measure it before and after fabtech told me it's only a 3inch lift

 

[Adam10532]

There is some cutting, well more like trimming, mostly to provide clearance for the front diff to drop down. The truck rides like it did stock. Fabtechs way of adjusting the magneride sensors up front is not adequate, but fabbing a bracket up fixes that and re-centers the sensor. I also think they should reduce the rear lift height by 1". With kit installed there is 2" of rake still, not a leveled stance.

call fabtech they just sent me a rear 1 inch spacer because my rear has 2 inch rake and i cant stand it they are pretty cool people and can send you a spacer free of charge. can post a picture next weekend when it gets installed

 

[Adam10532]

My '16 Denali XL with Fabtech 4" kit, 20x10 Fuel Tritons and 33x12.5 Fuel Gripper M/T's.

View attachment 69564

can you plz do me a favor and tell me how high is your airdam from the ground at its lowest part preferably like this

 

[Undeserving]

Great looking rides.
Curious what is the preferred brand of leveling kit? I have a 17 Sub Z71 with a noticeable back to front rake I don't care for. I want it to sit level. If i pick up a little tire clearance in front great but going much larger with tires isn't my primary motivation. How difficult is a leveling kit to install on a 4x4 IFS truck? All my wrenching experience has been on solid axle 4x4s back in the day when D60 /D70 with a 205 case and NP435 trans meant something.

 

[AZCreeker]

@Ridechevy09 post that new hoe on 26x16! I saw these on the gram. Give us specs but looks like FTS 10" with coilovers, specialty forged 26x16 on Fury 37s.

What happened to your Tahoe?
Is there a name/genre for this style ?
How do you load all kids, guests, Cherios, camping gear?
I am so curious!