Search results

  1. T

    CSFI to MPFI conversion identification

    The link doesn't work anymore. Search Amazon for Delphi FJ10566 Today it's just $224...
  2. T

    power steering hose

    16mm on top or 5/8, 18mm or 3/4 (a tad loose...) on bottom. Don't forget the o-rings... I had to pull the AC bracket. Pain in the butt... Best explanation from Mark Simko: OK, for the record, the large aluminum bracket did need to be removed from the engine. To do this: 1. remove the top...
  3. T

    pulled the trigger... LQ4/4L80 swap (6.0 vortec)

    Cool project. I've got a '96 Hoe that could use some 6 liter love. Might be a good excuse to drop the Hoe engine into my '71 Blazer... Wish I had more time and $$$. Watching this thread. Good luck, Tony ---------- Post added at 05:37 PM ---------- Previous post was at 05:32 PM ----------...
  4. T

    Debadging & Polishing my 96'

    Any place that has detailing supplies, including most auto parts stores. http://www.amazon.com/gp/product/B003UE2OWA/ref=pd_lpo_k2_dp_sr_2?pf_rd_p=486539851&pf_rd_s=lpo-top-stripe-1&pf_rd_t=201&pf_rd_i=B001O7I7JE&pf_rd_m=ATVPDKIKX0DER&pf_rd_r=0V3GDEA612R500Z1V513
  5. T

    Debadging & Polishing my 96'

    Clay bar is a less aggressive way to get down to the clear coat. Usually used prior to a full detailing job to get the nicest surface to start with. It cuts through sap and other crap that builds up on the clear coat. Compounding is a more aggressive buffing that uses paste-based abrasives...
  6. T

    Debadging & Polishing my 96'

    It sounds more like oxidation. Try clay bar on a spot and see if you can polish it out. There's a good chance your truck just needs a good compounding/buffing.
  7. T

    How to replace your fuel pump

    Thanks for the writeup. It's hard to believe nobody sells a pump that just plugs into the harness. Time for a little research...
  8. T

    New to the forum, first time tahoe owner

    Welcome!
  9. T

    installation kit...

    Isn't it the GM10 ant adapter? Also, if you want the deck centered in the 1.5 DIN space at the top, use this kit: http://www.amazon.com/Scosche-GM1483B-1995-02-General-Motors/dp/B000EIQMHS/ref=sr_1_1?ie=UTF8&s=electronics&qid=1289849713&sr=8-1
  10. T

    Sound system

    http://www.the12volt.com/
  11. T

    Torch Suggestions - Heating Bolts and other items...

    If you have a harbor freight near you, they sell a portable set that isn't bad at $279 complete with gas and 02 tanks. They sell the small tank refills, as well. Good if you don't want or need the giant tanks of a standard set. Plus the portable part is REALLY handy sometimes...
  12. T

    Removing chrome fender trim, Pain in the ass!

    Yikes! On the stubborn ones, make sure your phillips head is the right size and use a light hammer to tap the end of the screw driver. It should break the screw free. Also on tough screws and bolts, try tightening them a tad. Then they usually loosen easier.
  13. T

    programing remote key fob

    For a pinout of the data port see this: http://www.programyourremote.com/classified/DisplayAd.asp?id=375
  14. T

    Keyless Remote (Key Fob)

    Just reprogrammed a used one I got off ebay for $12 shipped. Reprogramming is super easy on these trucks. Also picked up one for my wife's Durango and it was even easier (no jumper needed...) Great looking 2-door!
  15. T

    Another new old Tahoe owner

    The difference between being a daddy or not... :) Later, Tony
  16. T

    new guy here

    Nice truck.
  17. T

    The Slamahoe

    Nice looking fleet you got there, Effeckt. The Slamahoe looks sweet, strungout2000.
  18. T

    Started demolding today =) (PICS)

    Thanks. Too bad...
  19. T

    Debadging & Polishing my 96'

    I agree it would look better without the trim, but if you have issues underneath, you could always go with the black wheel well trim from LMC. It's only $50 or so and wouldn't stand out as much.
  20. T

    Another new old Tahoe owner

    The big block has always been a real thought on the '71, I'd love a 502 backed by an NV4500 5-speed. Don't know if I could afford the fuel, but I don't pass many gas stations as it is... lol. Good luck with your health and getting back to restoration. I enjoy it almost as much as driving. :)
  21. T

    Another new old Tahoe owner

    So far, I'm enjoying the ride quality. I so used to the kidney punches from the '71, the leather couch and boat-like float are a little seductive... Given my need to tweak, I'm sure I'll want it stiffer, at least. I need to pull a 4-horse trailer, so power and possibly some Dana 60s might...
  22. T

    Started demolding today =) (PICS)

    Is the front bumper molding just glued on, as well? '96 Tahoe Thanks, Tony
  23. T

    Another new old Tahoe owner

    Thanks. You can see the '71 hiding in the back of the last photo. For more pics, click here. Tony
  24. T

    Another new old Tahoe owner

    Just wanted to drop a note and thanks for the great forum. I just picked up a '96 Tahoe with 241K miles. I've been looking at them for quite awhile and was really looking to get a newer 6.0 liter, but the price was right on the '96 and after a close inspection and test drive, I grabbed it...

Forum statistics

Threads
129,114
Posts
1,810,655
Members
92,202
Latest member
Phoenix2k9

Latest posts

Top