I’ve already pulled it down and got the switch out. Just not sure which wires to connect or apply power or ground to, to see if I can activate the motor
Anyone know how to do this for an 07? Need to isolate.
Hoping to eliminate some variables on this diagnosis, anyone which wires to test or jumper to open and close?
Found something for the prev. body style but nothing for this gen and the connectors look different.
Can anyone please help me...
Anyone know how to do this for an 07?
Hoping to eliminate some variables on this diagnosis, anyone which wires to test or jumper to open and close?
Found something for the prev. body style but nothing for these, and the connectors look different and I believe go through the BCM?
ABS tone ring could have gone out too. It sits inside after the axle bearing on the rear. I've seen wheel bearings go and chew/gunk that whole area up and need work done to rectify.
That’s a good point. I ended up finding a Moog LCA open box for $42 shipped so I’ll see how that works out. Will be able to measure once I get the oem alu one out.
Not to bump an old thread, but I'm looking at doing this also. Does anyone know approximately how much weight difference there is per LCA? alu vs steel
Want to see how much I'd gain in weight going from alu to steel to save cash on the repair. I don't care about the weight savings if its only...
Heeeey guys can we get these pics reuploaded? Need to do my lowers soon.
They do not appear for me. I know its way after the post was made but this topic is totally still relevant.
Hope this helps. I haven’t made everything all tucked and neat yet. Still trying to figure out why my liftgate won’t close on its own before I bundle everything up nice and put the panel back on.
Okay sweet!
So on the factory camera harness plug that is not the furthest one to the rear but the one right before that (picture of it) I cut and spliced 3 of the wires and left one cut.
1 cut gray wire and left alone
2 Orange wire (factory 6v wire) wired this to the short red wire coming out...
Nice! Finally got mine working. Used 12v off the rear wiper, and 3 wires off the original camera harness (everything except the oem camera 6v from the harness)
OK--
I tried to hard wire it last night. I found a good 12v on the reverse light power that I spliced into. Checked out fine with the voltmeter.
I used the ground on the factory camera harness-- this did not work, need to find a different ground.
When I tested it the other night I just ran the...
Hey gang,
I looked around here and online elsewhere, having trouble finding, does any one know what the most recent Nav/navigation disc version is? I suspect I have an old version.
I'm debating changing head units or updating the current one if I can find a cheap/current disc.
Thanks,
edit...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.