Hi. did you ever get this P069E error continue to pop up? I have a 09 Denali and it occasionally pops up. this time my cruise control was having issues enabling and then the check engine popped up and this code showed up again on its own
Sent from my iPhone using Tapatalk
The more I research, the more I think this is an issue with the fuel pump flow control module and occasionally shorting out and throwing the P069E code. I've erased it and engine runs find and then randomly the car stalls. I shut the car off, take the key out, open/close the door and restart...
My OBD scanner tool did a Fuel Pressure read and it was averaging 43 psi for my 2009 Yukon Flex 6.2L. Seems low as I read that it should be between 50psi to 100 psi.
Would think this is fuel pump issue and I should replace it. 179k and 11 years with about 4000 engine hours on the original...
OK, My 2009 Yukon Denali finally needs to be replaced. Using AC DELCO MU2139 assembly and sender. 179k miles and it's finally started to stall on occasion. Have you all also replaced the fuel filter? For 11 years, I've only tanked it with Chevron fuel with the occasional Flex Fuel when...
tighten all the posts and mounts to the chassis. Simple check may help remove the electrical issues. Mechanics often forget to tighten the posts after doing any basic work requiring to power down vehicles
How’s your dash look? I have a ‘09 and almost same... complete Tran rebuild, Arnotts, 175k and only been lubricated w Mobil1. installed the K&N smog legal intake. Looking to sell soon.
Sent from my iPhone using Tapatalk
My 2009 Denali AwD tranny died at 160k. i found a reputable shop and I went with a complete rebuild. $6k. Big decision for me too but I plan to keep this baby for another 5 years so I went ahead with it and have to say that it feels like a champ. At that point also replaced all the shocks...
Check all the ground connections AND positive terminal connections from the battery. I stumped myself for two weeks trying to dig into the warning messages and realized that the terminals weren't bolted snug to the battery and all my electrical error messages disappeared.
Tagging myself into this thread. Have a '09 and about 150k. despite only using synthetic fluids where possible and timely fluid changes to engine, trans, differentials, transfer cases.... had to recentlychange the rear main seal (knock on wood) on a tranny rebuild and had to replace the...
You can get buy not replacing the motor mounts, however if you do intend to do work on the engine, then might as well do the mounts. Mine were broke and i drove for 75k and recently replaced them when i overhauled the tranny. The rebuilt tranny should last you another 50k-100k.
Went to RockAuto and got a great deal on Arnott rear shocks (AS2700) and front springs and shock (SK2954) for my 09 Denali. *knock on wood* but my compressor is still operating. 150k miles and should've changed it out a couple years ago. Ride is great and responsive. Had to hit some...
bummers. out here in CA labor costs are higher so my full rebuild is $3400. they could’ve just repaired a few items and it would’ve cost me sub 2000 but at that point i went with a full rebuild
my 2009 Yukon Denali was having hesitation issues in stop/go traffic and having a hard time downshifting back into first gear. Normal and high speed, no issues. But with LA stop/go I'd have situations where it would not go back into first and in a full stop i was starting my acceleration in...
here are two links... but currently, they are sold out. Believe the GMC bulb size for reverse lights are 7442 but the 7440 works:
http://www.v-leds.com/Exterior-LED/Turn-Signal-LED/White-LED/2-WHITE-V-LEDS-7W-HIGH-p6302215.html...
@scotto2323: i just installed the same setup including vanity LEDs and puddle lamps. mine dont flicker.. they just shut off when (when it's supposed to dim out)
it's a low beam kit. other than needing to "flash" someone, there won't be a need to use the high beam in "extreme" conditions. though i know there are peeps out there that wont go for the HID kit because of that. my wife drives an X5 which has the projection xenon lights and this kit...
i just installed these exact front mud molded guards on my 09 Black Denali. It matches the factory black paint.. (Black 41U) if that is the guard m332i ordered
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.