I found this in my Yukon today. Never knew it was in there.
Anyone interested? I know some guys love the OEM stuff especially when it's pretty much brand new. Doesn't look like its ever been unrolled or even out of the pouch.
Chris
My fan shroud has two different belt routing pics. One with and one without ac. Part store shows listings for two different belts as well, same one with and w/o ac.
I have a 96 Yukon that the ac compressor makes a terrible sound at times. Not always. I am looking and needing to replace the belt anyway so am looking to get a shorter belt that will not go around the ac compressor does anyone know the length to use and also possibly routing info?
Thanks in...
Was swapping my radio out today a d decided to change some burnt out bulbs behind the instrument cluster. Found some extra plugs tucked under the cluster,I am wondering if anyone has any ideas on what they go too..
Thanks in advance.
What would cause my gas gauge on my 96 Yukon to fluctuate I can have a half tank and the gas gauge will go from half to empty and usually come to rest around empty.. Makes knowing how much gas in it a bit hard.. Thanks in advance.
Does anyone have a photo of how it should look or what the pads look like and what goes where.. If I take it apart I wont know whats what anyway if its installed right or wrong...
I don't see anything leaking.. Again all hardware in the drum is new. I can check on that. The abs isn't working the light is on gas been since I got it.
Now that problems kinda worked out I got another. I am having a problem with the rear passenger brake locking up if brake is pushed a hair harder than normal. Back brakes with all hardware were recently replaced brakes were adjusted than adjusted again and again. Still having the problem. Any...
Ok switched the rear passenger door switch with driver and wouldn't you know the window went up. Rolled it back down and back up again all worked fine or so it seemed. Rolled it down with the front switch it went down but wouldn't go back up with the front switch. Rolled up with the back one...
I don't have a gauge to check.. I'm pretty sure it's the motor. He must of had the window down some. The whole track is all rust.
Are the two rivets in the picture below holding the motor in??
What are the chances of both switches going bad at once??
Neither switch is working the driver door switch and the rear door switch either. I will have to look over what you posted later my phone doesn't make it easy.
It is not going either way anymore... Motor is not making any noise. All the other windows work just the one doesn't. I rolled it down this morning went to roll it back up and nothing..
---------- Post added at 09:13 PM ---------- Previous post was at 09:12 PM ----------
P.S thanks for the...
I just picked up a 96 Yukon from a friend and found that the driver side rear window motor does not work.. I found this out after rolling the window down. I can not figure out how to get the window motor out.. Every other one I have changed has had bolts and 2 minutes later replaced..
Heres...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.