What did you do to your NBS GMT800 Tahoe/Yukon Today?

SlowD · Apr 30, 2016

It's funny because when I was welding I was thinking back on how I remember seeing the shortened bent ones and wondered why, makes total sense now and i would think it would have been noisey or a crappy ride like mentioned but it's not. If it's even close when I check then I will reweld an offset bar to the center of the link.
Thanks for the clarification!

Rocket Man · May 1, 2016

SlowD said:
It's funny because when I was welding I was thinking back on how I remember seeing the shortened bent ones and wondered why, makes total sense now and i would think it would have been noisey or a crappy ride like mentioned but it's not. If it's even close when I check then I will reweld an offset bar to the center of the link.
Thanks for the clarification!

If you do that, when you move the swaybar to the right you can reuse the stock hole locations for the U-clamps on the passenger side and on the driver side, move that clamp so the left side of it uses the right hole and then drill a new hole for the right side of the clamp and get a nut and bolt for that hole. It's a real ***** to get a wrench on that nut though. DJM has instructions on their website I believe.

jcevans7 · May 1, 2016

Front driver side wheel is starting to squeak when I turn slowly under 5 mph. Pretty sure it's the wheel bearing not brake related. Any suggestions in brand or are they all the same?

Sent from my SM-N910T using Tapatalk

Drtyhoe · May 1, 2016

Mike

JoshM · May 1, 2016

JoshM said:
Got my Gibson exhaust on. After spraying the flange nuts the past 3 nights, install was easy-peasy. Nuts broke loose with nothing but a socket wrench. OEM exhaust cut with the reciprocating saw. New exhaust bolted up with ease. Sounds great without being noisy on the inside. Very happy with my purchase.

^ ***** magnet.

jcevans7 · May 1, 2016

Not finished have to go eat sone crawfish but knocking out this harness for the new stereo in between family and finals.

Sent from my SM-N910T using Tapatalk

Rocket Man · May 1, 2016

Solder and heat shrink , the only way to go.

jcevans7 · May 1, 2016

Red Rocket said:
Solder and heat shrink , the only way to go.

Do it once do it right I'd what I hear my dad saying. Didn't even pic that part up from the military.

Sent from my SM-N910T using Tapatalk

carduke · May 2, 2016

Flushed the front/rear diffs. Replaced the busted fog light.

Rocket Man · May 2, 2016

Did an oil change then my first good wash after completing the front color match.

What did you do to your NBS GMT800 Tahoe/Yukon Today?

SlowD

Full Access Member

Rocket Man

Mark

jcevans7

Full Access Member

Drtyhoe

Member

JoshM

TYF Newbie

jcevans7

Full Access Member

Rocket Man

Mark

jcevans7

Full Access Member

carduke

Full Access Member

Rocket Man

Mark

Similar threads

Forum statistics

Latest posts