I am trying to install a CCM 2.5 front and 1.5 rear leveling kit. I got the front installed with no problems. But the rear i believe is autoride. I take the bottom shock bolts out and lower the rear axle with a jack, but it doesn't lower enough to get the springs out? I have it lifted up high enough for room, but something is holding it from dropping far enough to get the springs out. Any ideas?
CCM Rear 1.5" Install
- Thread starter 914jpw
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
PG01
Supporting Member
Check all the brake lines? Air tube lines? Etc etc etc.......
01Konvict
Boats n Hoes
Air lines don't matter if removing bottom shock bolts. It's the sway bar bolts holding it up. After those are off it can swing down about 3" before brake lines get tight. You can unbolt the one diff bolt holding lines to free up some slack when going from 3-6" swing.
AppocAlexx
Darth Appocalexx
check that pesky breather line for the rear end mine was literally holding all the weight of the rear end when I installed my 1.5" spacer. I had the spot light in just the right place where I could not see it. It was just sitting there screamin. But I was basically done at that point and went along my way.
Similar threads
