My 5 Alarm Hoe

05Single said:

Looking all official now like a go

Click to expand...

Tonyrodz said:

Nice!!

Click to expand...

Thanks

Fosscore said:

Nice job on that custom grille work for the light bar.

Click to expand...

Thanks, it wasn't too bad... the hardest part was getting the grille back in with the pushbar in the way

05Single said:

Looking all official now like a government vehicle. From the front, from the side and rear that's a different story lol
I can see drivers moving out of your way

Click to expand...

Lol, it will look official once I throw on my emergency lights and a siren I have laying around

Most drivers move out of my way once they see a pushbar on their ass lol

As long as the weather stays nice...the mods will keep coming and my wife will stop breaking my balls about all the boxes in the house for the Hoe

I added another two 6'' led light bars to the grille...BUT...thanks to my annoying pain in the ass know it all neighbors I got distracted and cut the grille in the wrong place and had to remove the grille AGAIN fix my **** up and repaint AGAIN

As soon as I finish everything my wife calls me and tells me another big box came lol...after all this my new powder coated black mesh grille arrived





Here is where my PIA neighbor caused me more work...notice the pushbar is blocking the led's



Relocated the lights

Here's a little tip for anyone running wires through the firewall...always make sure you pull an extra cable/string so you don't have to deal with the nightmare of snaking your way through there again

Lookin good , every install can't always turn out perfect. Learn as we go, mod life!

I would think those smaller lights would look good in the fog location too.

Cattivo said:

Here's a little tip for anyone running wires through the firewall...always make sure you pull an extra cable/string so you don't have to deal with the nightmare of snaking your way through there again

View attachment 75319

Click to expand...

Just make sure once the wires are through the firewall they don't chafe, and wear through the insulation. It'll cause you a headache.

Tonyrodz said:

Just make sure once the wires are through the firewall they don't chafe, and wear through the insulation. It'll cause you a headache.

Click to expand...

Rubber grommets ftw. Worth it not to be lazy, learned my lesson the hard way when I was a young buck just starting out in the mod world.

05Single said:

Lookin good , every install can't always turn out perfect. Learn as we go, mod life!

I would think those smaller lights would look good in the fog location too.

Click to expand...

I have a ton of led light bars left over from my old Jeep build that were never installed. I'm still contemplating wether to run fogs or not

Tonyrodz said:

Just make sure once the wires are through the firewall they don't chafe, and wear through the insulation. It'll cause you a headache.

Click to expand...

So true! I found the best and easiest way through the firewall grommet is going in on a 45 degree angle on the lower right hand corner... should poke out near the emergency brake