Horrible ride! On the highway at 60 me and my passenger were borderline scared for our life. I traded for some oem Silverado SS wheels and the ride quality instantly dramatically improved
What did you do to your NBS GMT800 Tahoe/Yukon Today?
- Thread starter vwbeaner
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
brian.roberts.1293
Full Access Member
How much is the deadner costing ya
Sent from my SAMSUNG-SM-G935A using Tapatalk
Sent from my SAMSUNG-SM-G935A using Tapatalk
Thanks. Only a few hours. It would suck to do this by hand. The old 10" random orbit buffer did great.
Yeah, it came out nice for only using stuff you can buy at Walmart. Apparently ALL whistles are very clean??? lol
massivespl
I'm not mean, I'm honest.
Something ain't right then cuz I can go 97mph with my 26s no shakes... my buddy has ppv Tahoe on 26s and we got 120+
I don't remember. I bought it when I installed the sub in the rear quarter. I want to say like $80
I will say my 11 Sierra was easier the Tahoe!
Sent from my iPhone using Tapatalk
Jtayl152
TYF Newbie
- Joined
- Aug 6, 2016
- Posts
- 11
- Reaction score
- 37
Picked up a set of denali chrome interior handles, dash bezel and cluster for my '02 last weekend and finally got around to installing it all. I added LEDs to the cluster while I had it out, getting the trans temp is my favorite part!!
mdnitedrftr
Full Access Member
Something was definitely wrong but didn't want to invest even more money into them. Bought em used and replaced all tires so there's no telling what it could have been. But now it rides great so I guess that's all that matters and the SS wheels look dope 2
SnowDrifter
Full Access Member
- Joined
- Sep 5, 2016
- Posts
- 2,405
- Reaction score
- 2,591
PCV catch can.
Ebay thing. Quality isn't bad. Not great either. Milling is a bit rough and it had a bunch of aluminum shavings left inside from tooling. I think I might disassemble it and tweak with the internals as there's no gasket dividing the two sides, it's not 100% efficient right now
I also noted I need to clean under my engine cover LOL
Ebay thing. Quality isn't bad. Not great either. Milling is a bit rough and it had a bunch of aluminum shavings left inside from tooling. I think I might disassemble it and tweak with the internals as there's no gasket dividing the two sides, it's not 100% efficient right now
I also noted I need to clean under my engine cover LOL
