Recent content by slypher25aussie

  1. slypher25aussie

    What’s this noise??

    What should I look for for a worn out CV joint?
  2. slypher25aussie

    Two New Trucks

    I have direct replacement LEDs in my Denali. They plug and play with the factory connector and twist right into the socket. Had them for almost 3 years now with no issues. Highly recommend. As far as the foggy lenses, you can sand and polish them to get rid of the damaged layer, or pickup an...
  3. slypher25aussie

    What’s this noise??

    Thanks everyone for the input. I haven’t had a chance to jack it up and check for play yet. Question… it’s better to replace the whole hub rather than just the bearing, correct?
  4. slypher25aussie

    What’s this noise??

    Wheel bearing? Squeaky toy?
  5. slypher25aussie

    2001 Tahoe Radio Volume Not Adjusting

    I know this sounds counter intuitive, but instead of replacing the amp (if that is the problem) you might consider replacing the radio with an aftermarket head unit and bypassing the amp (properly of course ;)).
  6. slypher25aussie

    2001 Tahoe Radio Volume Not Adjusting

    My guess would be to start tracing those wires from the previous owner. If they had a aftermarket head unit installed, they likely bypassed the factory amp.
  7. slypher25aussie

    2001 yukon electrical issue

    Aaaaaand crickets lol. But in the off-chance the OP comes back to read and reply... you said your battery is good. How do you know? Was it tested professionally to be good? You said you start and stop the truck all day. That would wreak havoc on a battery. Is it cold in the morning where you...
  8. slypher25aussie

    2001 Tahoe Radio Volume Not Adjusting

    You don't have the Bose radio right? I know in my rig, there is a Bose amplifier that must receive the signal to turn on, otherwise no sound.
  9. slypher25aussie

    2001 Tahoe Radio Volume Not Adjusting

    That’s quite a hack job back there that someone did. That black box is not factory. Looks like an AUX adapter. I also see someone added an in-line fuse in that yellow holder attached to the red wire. Have you checked if that fuse is good? No idea what it’s for, but may as well rule that out too...
  10. slypher25aussie

    Gas pedal

    I don't think the problem is that the throttle is too sensitive, it's the physical spring on the gas pedal. There's no "dampening" or whatever. Causes it to be springy/bouncy. Especially when going over bumps or rough road. Your foot keeps bouncing the gas pedal. Think of it like a car with...
  11. slypher25aussie

    Gas pedal

    They don't make 'em for our generation of trucks :(
  12. slypher25aussie

    Gas pedal

    My '03 Denali is the same way. IIRC everyone's is. Very springy gas pedal. You just kinda get used to it after awhile.
  13. slypher25aussie

    2006 Yukon XL Power Driver seat isn't working, and neither heated seats

    Good find. Likely the seat bottom pad is bad like I mentioned. I went to a junkyard and pulled one off of a seat there.
  14. slypher25aussie

    Unable to adjust settings on DIC

    Not necessarily. It could be intermittent and starting to fail, but still have some functionality. When mine went bad, it would mostly work, but sometimes if I had the steering wheel at just the right angle, like turning on a freeway overpass and tried to adjust the volume of the radio, it...
  15. slypher25aussie

    2006 Yukon XL Power Driver seat isn't working, and neither heated seats

    Correct. I was just addressing that particular issue. I vaguely remember something about if the brake switch or even something as small as a brake bulb was faulty, it would disable cruise control, power seat functionality, and the seat memory function. I could be remembering wrong though.
See more

Forum statistics

Threads
129,398
Posts
1,815,353
Members
92,587
Latest member
dnbri512

Latest posts

Top