It was about 10 F last night when I drove back from EWR. The check engine light was on.
The code is P0101 MAF performance problem. Would low temperature cause MAF malfunction?
I just had P0206 and P0300 on new year day. What would come next?
Report back. I replaced the oil pressure sensor today. The problem was solved.
I bought the sensor from RA and hope it will last for a few years. Can't trust the sellers on Amazon.
Appreciate for the help from all of you guys.
Best regards.
I appreciate the advice from you guys.
I sprayed wd40 at the roller and used pry bar to force the roller to rotate with door open/close.
It worked amazingly and magically. Thank you very much.
Thank you all for help. I finally had time to work on the problem tonight.
I removed the sensor and screen. They are all clean. The screen was not clogged.
I guessed the problem was from the sensor. Next I will order sensor to replace.
To remove the sensor for me, I had to remove the fuel line...
Thank you all for advice. I will start from sensor replacement.
I'm confused at what part # is correct for my car. I found different part #. Which one is correct for 2012 Denali 6.2L engine?
1. Amazon ACDelco Store: ACDelco 12673134, Dimensions(LxWxH) 2.9x1.6x1.2 inches (list as not fit 2012...
The truck is 2012 Yukon Denali XL with 90k miles.
This happened since yesterday. I did an oil change and it didn't help.
Please help to diagnose if this is because of the sensor, oil pump, o-ring or something else.
This is my only car. I can work on it during weekend. Just want to make sure I...
Thank you all for the advice. My roller does not rotate any more. The pin is kind of bend so the roller sticks.
I will try to push spring away and try to rotate the roller. Appreciate your kind help.
Hello,
The hinge is cheaper than roller pin. Should I change the hinge? Is it easier to work on hinge?
If I don't fix it, will the door be damaged? If it is only noisy, I will leave it for now.
Thank you for the advice.
Regards.
I did the same but with no beer and found that when my wife released the pedal, the air was suck in from the valve thread. So I went back to two-people way.
I'm just sharing my experience. You probably didn't loose the valve too much. It's worth to notice it.
From my experience, you may want to change both bulbs if they are halogen bulbs, wear vinyl gloves and don't touch the bulb directly with your fingers.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.