Recent content by joshcarl

  1. joshcarl

    Possible BCM/PCM issue?

    definitely don't have a tech 2. how much would I expect that to run?
  2. joshcarl

    Possible BCM/PCM issue?

    no codes
  3. joshcarl

    Possible BCM/PCM issue?

    So we've been having an intermittent issue where the truck does what it wants, and not in the cool Knight Rider way. The doors won't unlock, the alarm randomly goes off, and the truck shuts off about 30 seconds after remote starting it. This phenomenon only seems to occur when it's cold out...
  4. joshcarl

    What do you consider normal oil pressure?

    10psi per 1k RPMs minimum is what i've been told on other LS forums.
  5. joshcarl

    Oil leak from engine block off gasket...need help.

    easy. remove bolts from the cover and slide it, and the gasket, off. replace gasket and cover, torque bolts to 106 in/lbs, done. i'd post a .pdf, but the admins set the kb limit too low to upload them.
  6. joshcarl

    Cam shaft sensors

    there should only be one sensor. it's on the front (timing) cover. you'll need to remove the water pump to get to it, but that's not very hard.
  7. joshcarl

    rear defrost wires came off

    i soldered mine back on a few months back. still holding strong.
  8. joshcarl

    Driver master window switch

    sorry, i don't log on here too much. if memory serves me correctly, you only need to remove the top of the switch panel.
  9. joshcarl

    Driver master window switch

    i had a similar issue with a rear switch. take the assembly out, and disassemble it down to the contacts (small copper pads where the buttons interface) and clean them with a pencil eraser. worked like a champ.
  10. joshcarl

    Drl ?

    i did this on my GTO, and i'm looking at the Yukon now. the main issue is that the DRL power, as it routes from the relay to the actual line to the headlamps, never leaves the underhood fuse block, so tapping into it will be tricky. when i did my car, i actually went into the back side of the...
  11. joshcarl

    borla pro xs muffler for 5.3 yukon

    why not go with the 40358? it's the same overall size, but has the 2.5" in/out. http://www.borla.com/products/proxs_muffler_part__40358.html
  12. joshcarl

    Broken Motor Mounts

    $500 for a motor mount??? RockAuto has them for $25-100 each. you should be able to replace them in less than an hour yourself with just a floor jack and a block of wood to lift the motor up after unbolting them.

Forum statistics

Threads
129,528
Posts
1,817,257
Members
92,743
Latest member
Delgarcia
Top