Recent content by blatta1999

  1. blatta1999

    Help! I need somebody! Lol. Whining noise in video.

    Yea they also did replace the carrier bearing.
  2. blatta1999

    Help! I need somebody! Lol. Whining noise in video.

    Mine the rear diff cover had a small pinhole I assume from rusting over time that had allowed it to slowly seep out so I never just had a massive spot. An expensive lesson for sure.
  3. blatta1999

    Help! I need somebody! Lol. Whining noise in video.

    If you ever see a small drop under any spot don’t drive it till you fully investigate. Mine had a small spot so I said I’ll check it and drove it and ended up running it low. Cost me all this trouble and money. Lol.
  4. blatta1999

    Help! I need somebody! Lol. Whining noise in video.

    Picked it up today. Noise gone. Ended up needing pinion bearing and gears. Main chunk fine. Went ahead and did new calipers and rotors and pads on rear. Also passenger bearing was bad but wasn’t the whole problem.
  5. blatta1999

    Help! I need somebody! Lol. Whining noise in video.

    I took it to a pro after all of my troubleshooting pointed to the rear end. I’m a shade tree at best so I wasn’t going to tear into the rear.
  6. blatta1999

    Help! I need somebody! Lol. Whining noise in video.

    Pinion bearing shot. Had play. Gears had some damage so getting the rear pinion bearing swapped and gears. Also, getting a few other things done to hopefully keep her running for years. The oil level running low looks to have cause the damage.
  7. blatta1999

    Help! I need somebody! Lol. Whining noise in video.

    It has the dash buttons and says it is in 2hi
  8. blatta1999

    Help! I need somebody! Lol. Whining noise in video.

    It is 4wd yes
  9. blatta1999

    Help! I need somebody! Lol. Whining noise in video.

    Small fine little pieces
  10. blatta1999

    Help! I need somebody! Lol. Whining noise in video.

    No this was kind of a paste consistency stuck to the magnet with fine shavings similar to sharpening a pencil.
  11. blatta1999

    Help! I need somebody! Lol. Whining noise in video.

    I had read when you change the fluid you will have small flakes that attach to the magnet. And I had a very small amount of that.
  12. blatta1999

    Help! I need somebody! Lol. Whining noise in video.

    I changed rear diff fluid and had just a few shavings. Otherwise all looked good and the gears looked clean. I swapped out tie rods because they needed it anyways. Noise is still there. Shouldn’t I have seen issues with the rear fluid or metal if there was a problem? Next is swapping passenger...
  13. blatta1999

    Help! I need somebody! Lol. Whining noise in video.

    150 thousand and not sure about rear end work. Have had the vehicle a few years. Pulled pan and gears in rear end look good. Very minimal metal shavings. Level was a little low. It appears the front passenger tie rod is about shot or fully shot. I bought new for both sides will swap them.
  14. blatta1999

    Help! I need somebody! Lol. Whining noise in video.

    Checking front wheel bearings, I found the passenger appears to be bad. And also it looks as though the tie rod on that side is also bad. Ordered parts and plan on tearing into it Monday. Also ordered fluid to change rear diff and check fluid and any signs of wear. Vehicle will be setting until...
  15. blatta1999

    Help! I need somebody! Lol. Whining noise in video.

    It seems as though it isn’t the rear end due to no clunking or any rough driving. It sounds like a rubbing. The link to the video of the sound might help. I checked front wheels and it didn’t seem that the bearings are bad. Just by rocking them and spinning them. That might not be a foolproof test.
See more

Forum statistics

Threads
129,195
Posts
1,811,963
Members
92,297
Latest member
btheboyscout

Latest posts

Top