I could still hear the noise when I spun the pulley by hand but I replaced the belts (ahead of schedule) and the noise subsided. I replaced them with "gates" and noticed a pretty big difference in ply/thickness.
The alternator in my 08 yukon is screeching when I accelerate. I removed the serpentine belt and can hear the same sound when I manually spin the alternator pulley. The voltmeter occasionally drops from 14 to about 12 volts, but I'm not getting any instrument panel warnings. The GM service...
I've got a 2008 Yukon XL. The automatic liftgate opens fine and lowers as usual. The problem is that when I push the liftgate button to close it lowers to the point of locking but just opens up again. I can physically lower the gate by hand and it stays shut.
Any thoughts or simple fixes?
Driver side actuator went out on my 08 yukon (36K+ miles) last week and the dealership replaced it in about 30 minutes. Didn't even ask for warranty paperwork. Said GM got a bad batch.
Door gap issue fixed
I fixed the issue by placing a 2 X 4 at the bottom hinge and slowly pushing the door in. I guess the area of the chassis where the hinge is attached had just slightly bent out when the wind caught the door.
I heard a popping noise when i was getting into my 08 yukon XL and noticed that the bottom half of the driver side door and front quarter panel were meeting (no gap). The door closes and locks fine. The only thing that appears shifted is the door. I took it the collision department of the GM...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.