Metal Part inside the foglight is loose --- help

[tom q]

ok finally got the 3000K and installed it. Just a bit of problem. The metal "thing", "reflector" whatever it is called inside my fogs came off. How do I get those out of there.

In other words, how do I remove/install the lens so I can remove the metal part?

If I buy an OEM replacement from ebay, will the 880 HID bulbs fit?

http://cgi.ebay.com/ebaymotors/00-06-GMC-CHEVY-SUBURBAN-TAHOE-OEM-FOG-LIGHTS-LH-RH_W0QQcmdZViewItemQQ_trkparmsZ65Q3a12Q7c66Q3a2Q7c 39Q3a1Q7c72Q3a1205Q7c240Q3a1318Q7c301Q3a1Q7c293Q3a 1Q7c294Q3a50QQ_trksidZp3286Q2ec0Q2em14QQhashZitem5 3db708fa1QQitemZ360163872673QQptZMotorsQ5fCarQ5fTr uckQ5fPartsQ5fAccessories

[tom q]

Help?

[Rollin Thunder]

you will need to replace them. Which isnt a bad thing. The metel shield thingy in my silverado fell off too. Yes the 880 kit will fit. So go ahead and order those.

[tom q]

thanks RT. Will the replacement foglight give off better light than the stock housing.

[Rollin Thunder]

it might because its new and fresh. But its the same design as the stock one.

[tom q]

thanks again...on my way to ebay