Recent content by travo87
-
Mysterious miss
I rebuilt the tbi all new gaskets on the engine and I have figured it out it was a loose distributor- travo87
- Post #14
- Forum: Engine & Drivetrain
-
Mysterious miss
Well I figured it.out and it is running amazing it was a loose disturbutor all along Thanks guys- travo87
- Post #12
- Forum: Engine & Drivetrain
-
Mysterious miss
I wish I could tell you I have no Fuel pressure tester might have to borrow one- travo87
- Post #9
- Forum: Engine & Drivetrain
-
Mysterious miss
And in which you have provided excellent help everything is fixed except this one thing and I can't figure it out even with the 1300 and rhe 1500 page books I have foe this thing but I'm just stumped- travo87
- Post #8
- Forum: Engine & Drivetrain
-
-
Mysterious miss
I've got a 95 yukon 5.7 tbi 4x4 217xxx I've basically rebuild this whole engine and every thing couple things I haven't changed only cause I know there good, but I have this mysterious miss or something like engine cutting out if I give it a little throttle driving or not it'll act like it want...- travo87
- Thread
- Replies: 14
- Forum: Engine & Drivetrain
-
-
Heater not blowing any heat
Yes heater is fixed unplugged wire hidden wire couldn't see until I took the hvac control oit the truck- travo87
- Post #7
- Forum: General Discussion
-
Need help rear speaker
The front door speaker wires, on each driver's side and passenger side they Noth have the matching colored wires thst matches the one in front of it. And if your truck comes with rear door speakers is awesome mine didn't but it did come the wires for it- travo87
- Post #26
- Forum: Audio & Electronics
-
Need help rear speaker
You can if ya haven't figured it out by now let me know- travo87
- Post #25
- Forum: Audio & Electronics
-
Heater not blowing any heat
OK so the other day my cousin took my radio out of my truck to get my audio wires out to use well ever since then and I don't know why but since then my heater doesn't work no heat no lights on the knobs and no actuators working only thing that works is the blow motor everything is hooked up on...- travo87
- Thread
- Replies: 7
- Forum: General Discussion
-
95 yukon sputtering mising
OK so everyone who has been following along on here with me on this yukon missing sputtering well now it won't start don't know why can't figure it out so I wnr ahead and started tearing it down from the intake and so forth. Well I got the intake off and I come to find out why my egr wasn't...- travo87
- Post #19
- Forum: Engine & Drivetrain
-
95 yukon sputtering mising
It's a 95 it doesn't have a crank shaft position sensor- travo87
- Post #17
- Forum: Engine & Drivetrain
-
2021 GMC Yukon w/40k miles began sputtering/jerking at slow acceleration
If ya haven't figured it out by now change out your fuel filter and maybe run a injector cleaner in there with a high octane fuel and or something to break up all that crud out the injectors- travo87
- Post #15
- Forum: Engine & Drivetrain
-
95 yukon sputtering mising
OK so real quick, what would make the rpm needle bounce radically back and forth when accelerating but at idle purrs like kitten curious about this one thanks yall foe all the great info advice- travo87
- Post #15
- Forum: Engine & Drivetrain
